[cisco-voip] SRST Question

[Lelio Fulgenzi]

sure you can, just set up dial-peers. however, you'll need to enable h323 to h323 or something like that. if you have two voice gateways, you can even setup HSRP and have them both act as an SRST router for full redundancy. 

--- 
Lelio Fulgenzi, B.A. 
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1 
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN) 
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
Cooking with unix is easy. You just sed it and forget it. 
- LFJ (with apologies to Mr. Popeil) 



From: "steve siltman" <steve.siltman at assurant.com> 
To: cisco-voip at puck.nether.net 
Sent: Tuesday, August 24, 2010 11:04:29 AM 
Subject: [cisco-voip] SRST Question 

Fun question I hope. 

I have a location with 2 voice gateways. When the phones go into SRST mode, is it possible to dial out the 2nd voice gateway from a phone that is registered to the 1st voice gateway? 

Thanks, 

- Steve This e-mail message and all attachments transmitted with it may contain legally privileged and/or confidential information intended solely for the use of the addressee(s). If the reader of this message is not the intended recipient, you are hereby notified that any reading, dissemination, distribution, copying, forwarding or other use of this message or its attachments is strictly prohibited. If you have received this message in error, please notify the sender immediately and delete this message and all copies and backups thereof. Thank you. 
_______________________________________________ 
cisco-voip mailing list 
cisco-voip at puck.nether.net 
https://puck.nether.net/mailman/listinfo/cisco-voip 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100824/038d96cf/attachment.html>