[cisco-voip] CUCM 7.1 - adding IP Phone device

[Sajishkumar R]

set the IP Phone to Factory defaulty. it will work.

Thanks & Regards,
Sajishkumar R
Email:-sajishr2000 at hotmail.com

 


 




From: ngh at atksi.com
To: cisco-voip at puck.nether.net
Date: Fri, 27 Aug 2010 06:46:48 -0400
Subject: [cisco-voip] CUCM 7.1 - adding IP Phone device
















I am moving an IP Phone from one subnet/user to a different
user on a different subnet.

I have deleted the IP Phone configuration in call manager;
however, when adding the same device (same MAC address) again in the call
manager, the call manager associates the phone with the old IPv4 address (even
though the phone is turned off).  The phone is booting up and getting a
different IP address on the new subnet, and is always in the “Registering”
state.  The phone has the right CM IP, TFTP IP, etc. the only difference
is the phone IP address and the IP address that the CM is showing in the phone
device configuration.  I also tried resetting/rebooting the IP phone.

In general where does the CM get the device IP address from?

Thanks,

George.

 

 







_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100831/98088f6e/attachment.html>