[cisco-voip] Inbound dial-peers

[Nate VanMaren]

I have some gateways that have connections to both the PSTN and to the PBX.

My general rule is that if a called number is 5 digits, it's from the PBX so don't route the call back to the PBX.

This worked great when I only had PRIs that were delivering 10 digit DNIS.  When it was 10 digits, I translated to the extension and allowed it to route the call to the PBX.

Now I have moved the PRIs that were connected to the PBX from PSTN, and they also are sending 5 digits.  So I run them through a translation on the gateway to turn that into 10 digits so the call manager will let the call go back to the PBX if it needs to.


So what I really want is a way to specify which ports I turn the 5 digits into 10 digits.  However voice-port is the 4th thing that is matched for inbound dial-peers.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

My main dial-peer is something like

dial-peer voice 2 pots
 trunkgroup QWest
 description ** QWest T1 PRI Inbound pots dial-peer **
 translation-profile incoming FROMPSTN
 call-block translation-profile incoming BadPeople
 call-block disconnect-cause incoming user-busy
 incoming called-number .
 direct-inward-dial


Any ideas from the group?

Thanks
Nate VanMaren
Engineer,Sr
CCIE #7911
ICS GOIS - Network Core
Information and Communications Systems Department
The Church of Jesus Christ of Latter-day Saints
VanMarenNP at ldschurch.org
+18012400624


 NOTICE: This email message is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message.