[cisco-voip] MGCP PRI Busy-Out

[Mark Holloway]

You can either busy-out the channels in Call Manager or you can do it directly on the router's PRI interface. 

HQ_Rtr(config)#int serial 0/0/0:23
HQ_Rtr(config-if)#isdn service b_channel 0-23 state ?
  <0-2>  Valid states are 0=Inservice 1=Maint 2=Outofservice



On Jan 18, 2010, at 4:51 PM, Nikola Stojsin wrote:

> A quick question ? is there a way to ?busy-out? specific channels on a PRI while using MGCP (I vaguely remember reading about it somewhere, but I cannot remember where).
> 
> Thank you, as always,
> Nikola
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip