[cisco-voip] Problem with 2951 and PRI outbound calls
Steve G
smgustafson at gmail.com
Wed Jun 2 02:20:35 EDT 2010
1 out of about 5 outbound calls ring once and then drop. You can hit redial
and the call will complete just fine. Telco switch is a DMS100 running ni2.
My equipment is a 2951 with a VWIC2-2MFT-T1/E1. IOS
c2951-universalk9-mz.SPA.150-1.M2.bin
I have a colleague with a similar issue who swapped his 2951 out with a 2811
and that cleared up all problems. Is there something with the 2951 that is
causing this problem? We are not having any luck with them. I have not
tried swapping this one out yet.
Below is some config snippets that you might want to see and a q931 debug of
a call that fails.
Thanks in advance!
Steve
network-clock-participate wic 0
network-clock-select 1 T1 0/0/0
isdn switch-type primary-ni
controller T1 0/0/0
cablelength long 0db
pri-group timeslots 1-24
interface Serial0/0/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
trunk-group PRI 1
no cdp enable
050310: *Jun 1 22:55:57.828 PDT: ISDN Se0/0/0:23 Q931: pak_private_number:
Inva
lid type/plan 0x0 0x0 may be overriden; sw-type 13
050311: *Jun 1 22:55:57.828 PDT: ISDN Se0/0/0:23 Q931: pak_private_number:
Inva
lid type/plan 0x0 0x0 may be overriden; sw-type 13
050312: *Jun 1 22:55:57.828 PDT: ISDN Se0/0/0:23 Q931: Sending SETUP
callref =
0x0081 callID = 0x890F switch = primary-ni interface = User
050313: *Jun 1 22:55:57.828 PDT: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8
call
ref = 0x0081
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98381
Exclusive, Channel 1
Progress Ind i = 0x8183 - Origination address is non-ISDN
Calling Party Number i = 0x2181, 'Snipped'
Plan:ISDN, Type:National
Called Party Number i = 0xA1, 'Snipped'
Plan:ISDN, Type:National
050314: *Jun 1 22:55:58.064 PDT: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd =
8
callref = 0x8081
Channel ID i = 0xA98381
Exclusive, Channel 1
050315: *Jun 1 22:55:58.072 PDT: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd =
8
callref = 0x8081
Channel ID i = 0xA98381
Exclusive, Channel 1
050316: *Jun 1 22:55:59.864 PDT: ISDN Se0/0/0:23 **ERROR**: L2_AdvanceVA:
TX_ac
k_queue empty
050317: *Jun 1 22:55:59.864 PDT: ISDN Se0/0/0:23 Q931: RX <- ALERTING pd =
8 c
allref = 0x8081
Progress Ind i = 0x8088 - In-band info or appropriate now available
050318: *Jun 1 22:55:59.864 PDT: ISDN Se0/0/0:23 Q931: TX -> STATUS pd = 8
cal
lref = 0x0081
Cause i = 0x80E0 - Mandatory information element missing
Call State i = 0x01
050319: *Jun 1 22:55:59.876 PDT: ISDN Se0/0/0:23 Q931: RX <- ALERTING pd =
8 c
allref = 0x8081
Progress Ind i = 0x8088 - In-band info or appropriate now available
050320: *Jun 1 22:55:59.912 PDT: ISDN Se0/0/0:23 Q931: RX <- DISCONNECT pd
= 8
callref = 0x8081
Cause i = 0x80EF - Protocol error; unspecified
050321: *Jun 1 22:55:59.912 PDT: ISDN Se0/0/0:23 Q931: TX -> RELEASE pd = 8
ca
llref = 0x0081
Cause i = 0x80E0 - Mandatory information element missing
050322: *Jun 1 22:55:59.964 PDT: ISDN Se0/0/0:23 Q931: RX <- RELEASE_COMP
pd =
8 callref = 0x8081
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100601/9174dfcd/attachment.html>
More information about the cisco-voip
mailing list