[cisco-voip] 回覆: RE: CME problem with H323

[Peter Slow]

David,
   You mention call park, what part is that playing here? i dont see
any call park dns configured. Can you send us the whole configuration,
and try tell us the specific issue and what party presses what
buttons?

though... you have the dial-plan pattern command in your
configuration. that is going to cause you to have that pattern+ephone
DN dial-peers automatically created.

even though you have the dial-peer 4000 voip with destination pattern 24094...,
because of your dial-plan pattern, if you do a "sh dial-peer voice
summary" you will notice that there is a virtual dial-peer for your
ephone. one will be destination pattern 24094001$ and the other will
be destination pattern 24094002$  ... Since these are longer, they
will match instead. the length of the match will be considered before
the preference. as a test, take otu the dial-plan pattern and see if
your problem goes away.

-Peter

2010/3/15 davidytk at netvigator.com <davidytk at netvigator.com>:
> Hi Daniel
>
> When I tried to remove ephone-dn configuration, the phone can be pass the
> dial-peer, but when I add ephone-dn configuration, the phone call the
> ephone-dn instead of dial-peer.
>
> i have set the preference to 9 under ephon-dn, the problem is same.
> Thanks
> David
>
> ----原始訊息----
> 寄件人: DDurkin at woodforest.com
> 日期: 16/03/2010 1:09
> 收件者: "davidytk"<davidytk at netvigator.com>, <cisco-voip at puck.nether.net>
> 主旨: RE: [cisco-voip] CME problem with H323
>
> Have you tried setting up a dial-peer for inbound such as:
>
>
>
> Dial-peer voice 3000 voip
>
> Incoming Called-number .
>
> voice-class codec 1
>
> voice-class h323 1
>
> dtmf-relay h245-alphanumeric
>
> no vad
>
>
>
> also run show dialplan number xxxx to see how your call is matching.
>
>
>
> Regards,
>
>
>
> Daniel Durkin
>
> Woodforest National Bank
>
> Voice Communications Engineer
>
> ddurkin at woodforest.com
>
> 832.375.2826 Office
>
> 832.375.3826 Fax
>
> 832.326.7780 Mobile
>
>
>
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of davidytk
> Sent: Monday, March 15, 2010 11:32 AM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] CME problem with H323
>
>
>
> Hi all
>
>
>
> I find a problem on CME with H323 GW. I have configured the following
> command. As I need to configure call-park under SRST, I use
> telephone-service instead of call-manager fallback command. I got a problem
> that when PSTN phone call 24094001, it always choose the number under
> ephone-dn instead going to dial-peer ( I have configure preference 1 on
> dial-peer). Any one know how to solve this.
>
>
>
> Telephone-service
>
>  Srst mode auto-provision none
>
>  Max-dn 10
>
>  Max-ephone 2
>
>  Ip source-route .X.X.X.X port 2000
>
>  dial-pattern 1 24094... extension 4
>
>  voicemail 4220
>
>
>
> ephone-dn 1
>
>  number 4001
>
>  presence 9
>
> ephone-dn 2
>
>  number 4002
>
>  presence 9
>
>
>
> voice class coded 1
>
>  codec preference 1 g711ulaw
>
>  codec preference 2 g729r8
>
>  codec preference 3 g711ulaw
>
>
>
> voice class h323 1
>
>  h225 timeout tcp establish 3
>
>
>
> dial-peer voice 4000 voip
>
>  destination-pattern 24094...
>
>  session-target ipv4:142.9.64.11
>
>  voice-class codec 1
>
>  voice-class h323 1
>
>  dtmf-relay h245-alphanumeric
>
>  presence 1
>
>
>
> thanks
>
> Best Regards
>
> David
>
>
>
> The information contained in this e-mail message is intended only for use of
> the individual or entity
> named above. If the reader of this message is not the intended recipient,
> you are hereby notified
> that any dissemination, distribution or copying of this communication is
> strictly prohibited.
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>