[cisco-voip] router to router (SCCP/h323 to SIP) calls don't work in SRST

[Nick Matthews]

Technically you should be able to point it at the other CME, and that
is what I would do.  Make sure on router B you have the proper
incoming dial peer, outgoing dial peer, and that you have
allow-connections for h323-to-sip, etc.

-nick

On Fri, Mar 26, 2010 at 10:16 PM, Lelio Fulgenzi <lelio at uoguelph.ca> wrote:
> ok, after some more reading, it looks like the default inbound dial peer
> won't work with SIP calls.
>
> which makes more sense, the configuration should really happen on the
> terminating router, not the originating router.
>
> thanks to Ed for some pointers.
>
> ---
> Lelio Fulgenzi, B.A.
> Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
> (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> Cooking with unix is easy. You just sed it and forget it.
>                               - LFJ (with apologies to Mr. Popeil)
>
>
> ----- Original Message -----
> From: "Lelio Fulgenzi" <lelio at uoguelph.ca>
> To: "cisco-voip voyp list" <cisco-voip at puck.nether.net>
> Sent: Friday, March 26, 2010 7:59:55 PM GMT -05:00 US/Canada Eastern
> Subject: Re: [cisco-voip] router to router (SCCP/h323 to SIP) calls don't
> work in SRST
>
> ya know, I think I just answered my own question after sending this off....
>
> i'm guessing I need a more specific dial-peer on the far end router which
> more closely matches the dial-peer on local router.
>
> so, something like this? the question is, can i use the router address or
> should i use the CUE ip address?
>
> hmmm, something to try later
>
> ________________________________
> Router A:
> !
> dial-peer voice 37063 voip
>  description Cisco Unity Express AutoAttendant (Default)
>  destination-pattern 37063
>  session protocol sipv2
>  session target ipv4:10.104.13.66
>  dtmf-relay sip-notify
>  codec g711ulaw
>  no vad
> !
> dial-peer voice 11111 voip
>  description Wild Card to vgw-jnhn-b
>  destination-pattern [1234567]....
>  session target ipv4:10.104.13.202
> !
> dial-peer voice 37000 voip
>  description SIP Wild Card to vgw-jnhn-b
>  destination-pattern 37...
>  session protocol sipv2
>  session target ipv4:10.104.13.202 (OR CUE IP address?)
>  dtmf-relay sip-notify
>  codec g711ulaw
>  no vad
> !
> ________________________________
>
>
> ----- Original Message -----
> From: "Lelio Fulgenzi" <lelio at uoguelph.ca>
> To: "cisco-voip voyp list" <cisco-voip at puck.nether.net>
> Sent: Friday, March 26, 2010 7:53:10 PM GMT -05:00 US/Canada Eastern
> Subject: [cisco-voip] router to router (SCCP/h323 to SIP) calls don't work
> in SRST
>
> Does anyone know if there is anything special you have to do to make calls
> from an SCCP phone on one SRST router to a SIP endpoint on another SRST
> router work?
>
> Here's what I have and can do:
>
> two routers in SRST mode
> all phones register properly, some to one router, some to another
> I can make a call from phone A on router A to phone B on router B (and vice
> versa)
> I can make a call from phone A on router A to Unity Express A on router A
> and be transferred to phone B on router B
>
> I can NOT place a call from phone A on router A to Unity Express B on router
> B.
>
> I'm pretty sure Router B is getting the call, because a "debug voice
> dialpeer all" started spewing out stuff on Router B like it was going out of
> style. It even showed matches. I can post the full debug next week, but just
> thought there would be a quick(?) answer.
>
> I think these are the relevant configs, but will post more if needed:
>
> ________________________________
> Router A:
> !
> dial-peer voice 37063 voip
>  description Cisco Unity Express AutoAttendant (Default)
>  destination-pattern 37063
>  session protocol sipv2
>  session target ipv4:10.104.13.66
>  dtmf-relay sip-notify
>  codec g711ulaw
>  no vad
> !
> dial-peer voice 11111 voip
>  description Wild Card to vgw-jnhn-b
>  destination-pattern [1234567]....
>  session target ipv4:10.104.13.202
> !
> ________________________________
> Router B:
> !
> dial-peer voice 37073 voip
>  description Cisco Unity Express AutoAttendant (Default)
>  destination-pattern 37073
>  session protocol sipv2
>  session target ipv4:10.104.13.70
>  dtmf-relay sip-notify
>  codec g711ulaw
>  no vad
> !
> dial-peer voice 11111 voip
>  description Wild Card to vgw-jnhn-a
>  destination-pattern [1234567]....
>  session target ipv4:10.104.13.201
> !
> ________________________________
>
>
>
>
> ---
> Lelio Fulgenzi, B.A.
> Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
> (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> Cooking with unix is easy. You just sed it and forget it.
>                               - LFJ (with apologies to Mr. Popeil)
>
>
> _______________________________________________ cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> _______________________________________________ cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>