[cisco-voip] MOH Multicast vs Unicast

[Ryan Ratliff]

Yes, the MOH server/source combo determines if unicast or multicast is used, and the server part comes from the device getting put on hold.  Enable all of your audio sources for multicast and they can do both.    Then it's just a matter of setting up the MRGLs so that HQ phones get a unicast MOH server and remote ones get a multicast server.


-Ryan

On Sep 28, 2010, at 4:04 PM, Mike Lydick wrote:

Is it possible design a blend Multicast environment where the HQ will use primarily unicast from the Software MOH and remote sites use Multicast from local route. I was thinking this was possible by enabling just 1 multicast server (to be used as the spoofed Local Router MOH multicast address) and all other servers are unicast. Limit the hop count to 2 and setup the local routers according (with the multicast config and single file for MOH).


Best Regards,

Mike Lydick


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100928/f1f93d97/attachment.html>