[cisco-voip] Cisco Emergency Responder 8.5(1) on UCS C-Series server require ESXi

[Shawn Wilson]

As per the release notes, you must run a supported hypervisor on the UCS
server, in this case ESXi 4.0+.  There is no "bare metal" installations for
the Cisco UC on UCS as far as I know.

http://www.cisco.com/en/US/products/sw/voicesw/ps842/prod_release_note0900e4b181941b1f.html#wp137889

Shawn

On Sun, Jan 30, 2011 at 8:11 AM, Jason Aarons (US) <
jason.aarons at us.didata.com> wrote:

> If I use a UCS C200 server with Emergency Responder 8.5 am I required to
> run ESXi or can I install Emergency Responder directly on the hardware
> without ESXi?
>
>
>
> Table 8 Supported UCS Platforms
>
>
> http://www.cisco.com/en/US/products/sw/voicesw/ps842/prod_release_note0900e4b181941b1f.html#wp137889
>
>
>
> ------------------------------
>
> [image: DDIPT] <http://dimensiondata.stream57.com/04141pm/>
>
> * Disclaimer: This e-mail communication and any attachments may contain
> confidential and privileged information and is for use by the designated
> addressee(s) named above only. If you are not the intended addressee, you
> are hereby notified that you have received this communication in error and
> that any use or reproduction of this email or its contents is strictly
> prohibited and may be unlawful. If you have received this communication in
> error, please notify us immediately by replying to this message and deleting
> it from your computer. Thank you. *
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110130/b7c5c404/attachment.html>