[cisco-voip] FAX in ATA 186 with CUCM

[Nick Matthews]

On the ATA change these settings:
audio 0x00150015
connect 0x0900400


On the gateway:
voice service voip
 modem passthrough nse codec g711ulaw


-nick

On Wed, Mar 30, 2011 at 10:42 AM, Abebe Amare <abucho at gmail.com> wrote:
> From most posts on Cisco Netpro forum, I gather ATA with SCCP does not work
> well and I can testify to that. Have a look at this thread
> https://supportforums.cisco.com/message/300078#300078, should be helpful.
>
> regards,
>
> Abebe
>
> On Wed, Mar 30, 2011 at 5:01 PM, sheref hf <sheref_hf at hotmail.com> wrote:
>>
>> Hi all,
>>
>> I have CUCM 7.1 with H323 GW .... I have ATA connected with 2 FAXes
>>
>> I already configured the two ATA ports took IP's and registered with CUCM
>> with Directory Numbers : 8012, 8013
>>
>> MY LAnd Lines that will work as FAX Lines on Ports 0/1/0 and 0/1/1
>>
>> what is additional configuration to make these two faxes work well ... and
>> uses the Faxes PSTN Lines ....?
>> the ATA already registered and took DN's .... only
>>
>> Thanks
>>
>>
>>
>>
>>
>> Best Regards,
>>
>>
>>
>> Sherif Ibrahem Mohamed
>>
>> Network Engineer
>>
>> Silicon21NIT Services
>>
>>
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>