[cisco-voip] Noise on BRI circuits.

[Robin Clayton]

Dear All,

After 8 months our installers 3 experts told us the reason they could not set up our remote sites SRST router was because the ISDN BRI lines were not active!

With no experience of ISDN config, it took me 30 mins to get the router answering calls from the ISDN lines and another half hour to push them to the call manager.


However, there is a massive amount of noise on the connection. Both when the router dial-tone is present and when the call is pushed to the phone on the call manager.

I can't figure out why!

Any ideas???

Thanks

Rob



--------------------------------------------------------------------------------------------------------------

Important Notice:

This e-mail and any attachment are confidentialand may be privileged
or otherwise protected from disclosure. It is solely intended for the
person(s) named above. If you are not the intended recipient, any
reading, use, disclosure, copying or distribution of all or parts of this
e-mail or associated attachments is strictly prohibited. If you are not
an intended recipient, please notify the sender immediately by
replying to this message or by telephone and delete this e-mail and
any attachments permanently from your system.

The Richard Rose Federation<http://www.rrfa.org.uk>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20120419/6c1032c3/attachment.html>