[cisco-voip] Partition Question

[Lelio Fulgenzi]

If you're trying to allow a particular set of phones access to SIP trunks, it's the CSS of that phone you have to change. That way, it has access to a set of route patterns that accesses those particular trunks. 

--- 
Lelio Fulgenzi, B.A. 
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1 
(519) 824-4120 x56354 (519) 767-1060 FAX (ANNU) 
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
Cooking with unix is easy. You just sed it and forget it. 
- LFJ (with apologies to Mr. Popeil) 


----- Original Message -----
From: "Neal Haas" <nhaas at co.fresno.ca.us> 
To: cisco-voip at puck.nether.net 
Sent: Friday, January 6, 2012 12:53:15 PM 
Subject: [cisco-voip] Partition Question 




What is the best way to send calls out a particular set of trunks? 



I have setup all of our VOIP phones on a Partition of “Internal” We want to route this out the SIP trunks, but I don’t want to route our faxes out the SIP trunk. 



So I had in my mind to create a Partition of “FAX-ONLY” and I create new CSS so that the calls go out the PRI’s, it works, also calling to and from the internal and FAX-ONLY it works, but when I try to call the number it does not work. Busy signal, So I do some digging the PRI’s are on a CSS that was not included in FAX-ONLY so I add the CSS of 1020 trunk. Still does not work. 



My coworker says that I did it wrong I only needed to change the device pool, to get the desired effect, I don’t think so. 



What is the best way to make a fax use a particular PRI for calling out? I want to make it easy for the techs to work with. 



Thanks 



Neal Haas 


_______________________________________________ 
cisco-voip mailing list 
cisco-voip at puck.nether.net 
https://puck.nether.net/mailman/listinfo/cisco-voip 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20120106/69f20fe0/attachment.html>