[cisco-voip] LRG with H.323 GWs not hunting

[Adel Abushaev]

There is a service parameter that by default is "False" to keep
hunting when H.323 gateway returns "Unknown number". I don't have CCM
with me right now, but if you search under Call Manager and "H.323"
you will find it.

Adel.

On Wed, May 2, 2012 at 1:48 PM, Khemani, Haresh <hkhemani at cppib.ca> wrote:
> Gateway config is pretty standard...
>
>
>
> voice service voip
>
> allow-connections h323 to h323
>
> allow-connections h323 to sip
>
> allow-connections sip to h323
>
> allow-connections sip to sip
>
> fax protocol pass-through g711ulaw
>
> h323
>
>   no h225 timeout keepalive
>
>   call preserve limit-media-detection
>
> modem passthrough nse codec g711ulaw
>
> sip
>
> !
>
> voice class codec 1
>
> codec preference 1 g711ulaw
>
> codec preference 2 g711alaw
>
> !
>
> voice class h323 1
>
>   h225 timeout tcp establish 3
>
>   h225 timeout setup 3
>
>
>
> controller T1 0/0/0
>
> cablelength long 0db
>
> pri-group timeslots 1-24
>
> description TO-PSTN
>
> !
>
> interface Loopback255
>
> ip address 10.35.255.111 255.255.255.255
>
> h323-gateway voip interface
>
> h323-gateway voip bind srcaddr 10.35.255.111
>
> !
>
> interface Serial0/0/0:23
>
> no ip address
>
> encapsulation hdlc
>
> isdn switch-type primary-dms100
>
> isdn incoming-voice voice
>
> no cdp enable
>
> !
>
> voice-port 0/0/0:23
>
> echo-cancel coverage 96
>
> bearer-cap Speech
>
> !
>
> dial-peer voice 200 voip
>
> description ** PRQPBXCCM02 **
>
> preference 1
>
> destination-pattern .T
>
> session target ipv4:10.35.69.31
>
> incoming called-number .
>
> voice-class codec 1
>
> voice-class h323 1
>
> dtmf-relay h245-alphanumeric
>
> ip qos dscp cs3 signaling
>
> no vad
>
> !
>
> dial-peer voice 201 voip
>
> description ** PRIPBXCCM03 **
>
> preference 2
>
> destination-pattern .T
>
> session target ipv4:10.78.161.31
>
> incoming called-number .
>
> voice-class codec 1
>
> voice-class h323 1
>
> dtmf-relay h245-alphanumeric
>
> ip qos dscp cs3 signaling
>
> no vad
>
> !
>
> dial-peer voice 10 pots
>
> description ** Local 10 Digits Dialing **
>
> translation-profile outgoing PSTN_OUT
>
> preference 1
>
> destination-pattern 9[2-9]..[2-9]......
>
> port 0/0/0:23
>
> forward-digits 10
>
> !
>
>
>
>
>
>
>
>
>
> ________________________________________________
>
> Haresh Khemani
> Voice and Network Analyst | Information Services
>
>
>
> From: ccieid1ot [mailto:ccieid1ot at gmail.com]
> Sent: May-02-12 3:18 PM
> To: Khemani, Haresh
> Cc: cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] LRG with H.323 GWs not hunting
>
>
>
> How does your config on the gateways look?
>
> On Wed, May 2, 2012 at 7:07 AM, Khemani, Haresh <hkhemani at cppib.ca> wrote:
>
> We have 2 x H.323 Gateways with a PRI connected to each. There is a Local
> Route Group with both H.323 Gateways in it. Route List points to this single
> LRG.
>
>
>
> We were doing some redundancy testing and I shut down the PRI on GW1 and
> outbound calls wouldn’t failover to GW2. I have the Stop Routing on
> Unallocated Number Flag set to disable in Service Parameters yet it wouldn’t
> hunt. Reset the RL, CCM service, GW no luck. Even tried RL with 2 RGs with
> each GW in its own RG yet does not work.
>
>
>
> CUCM version is 8.5.1.12900-7
>
>
>
> Any ideas?
>
>
>
>
>
> ________________________________________________
>
> Haresh Khemani
> Voice and Network Analyst | Information Services
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
>
> --
> duy
> CCIE #27737 Voice
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>