[cisco-voip] Installing COP Patch

[Haas, Neal]

It installs on the active partition only.

You don't need to do anything with the old version, unless you want to roll back to that one.


Neal Haas

From: cisco-voip [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Angel Roberto Castaneda
Sent: Wednesday, August 28, 2013 1:50 PM
To: Cisco VoIP
Subject: Re: [cisco-voip] Installing COP Patch

I apologize, this is the correct link:

http://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-20130717-cucm


Angel Roberto Castaneda

On Wed, Aug 28, 2013 at 3:48 PM, Angel Roberto Castaneda <hello at angelcastaneda.com<mailto:hello at angelcastaneda.com>> wrote:
Good afternoon all,

After reading the security notice below [1], I'm looking at installing cmterm-CSCuh01051-2.cop.sgn on our CUCM 9.1 cluster.

While preparing for it, I noticed that we have two partitions:

Active Version: 9.1.1.20000-5
Inactive Version: 8.0.3.20000-2

If I were to install the .cop file, will it apply it only to the active partition? If so, how do I upgrade the version on the inactive partition to match our current software levels, so I can use that as a backup in case the patching goes south?

Thank you,

Angel Roberto Castaneda

[1] - http://tools.cisco.com/security/center/content/CiscoSecurityNotice/CVE-2013-3393

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20130828/2f3b90a0/attachment.html>