[cisco-voip] One-way call connectivity

[Carlo]

Make sure you have a source-interface set in your voice service VoIP commands. 

When you have the call set up. Do a 'show VoIP rtp connection and look at the addresses on both ends. 

Sent from my iPhone

On Jul 5, 2013, at 9:13 AM, Candese Perez <trigena at gmail.com> wrote:

> I am troubleshooting an issue with inbound calls coming from an Ericsson PBX ta through a Cisco Voice Gateway to a Siemens PBX. 
> 
> When the call goes out from the Siemens through the Cisco Voice Gateway calls connect, however when an inbound call from the Ericsson gateway comes in it won't connect. 
> 
> Enabling several debugs has not produced any traffic, in fact I don't see anything coming into the voice gateway, where as I can see the traffic going out when initiated from the Siemens. 
> 
> There is a firewall between the two systems, however the firewall admins see udp traffic between the voice gateway and the Ericsson. 
> 
> I am curious as to why I am not seeing anything when running debugs, these are the debugs I have been running. 
> 
> debug voip ccapi all
> debug vtsp all
> 
> Are there other debugs I should be running?
> 
> Thanks!
> 
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip