[cisco-voip] dial peers and translations

[Nick Matthews]

For outbound no. Inbound it would be that case.  If this outbound call
failed, it would try to re-route on the original non-translated number as
well.

-nick


On Wed, May 29, 2013 at 12:43 PM, Erick Wellnitz <ewellnitzvoip at gmail.com>wrote:

> Simple question I just need a refresher.
>
> On my CUBE, if I translate-outgoing called xxxx on the dial peer does my
> destination pattern need to match the original number or the translated
> number?  The dial peer guides are not quite clear in my mind.
>
> Here is my dial peer and my translation rule.
>
> voice translation-rule 4000
>  rule 1 /^\+/ /9/
> ***replacing the + globalization with 9 for outbound PSTN access
>
> dial-peer voice 4000 voip
>  description Inbound Toll Bypass from XXXXX
>  translate-outgoing called 4000
>  preference 1
>  destination-pattern +16304######   <-----should this be 916304######?
>  session protocol sipv2
>  session-taaget ipv4:172.16.7.12:5070
>  incoming called-number +16304######
>  dtmf-relay rtp-nte
>  codec g711ulaw
>
> Thanks in advance!
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20130529/5922dada/attachment.html>