[cisco-voip] SCCP IP Phone + H.323 trunk + CUCME + changing called number

[Robert Hass]

Hi
I have PABX running CUCME and 79xx IP Phones (SCCP firmware). Traffic to
PSTN is done by H.323 dial-peer to other our Cisco in HQ. HQ Cisco gateway
have SIP Trunk to our carrier. Dial-peer
to carrier have applied outgoing translation where we add 4345# prefix to
called number.

My problem : when I calling outside called number displayed on the phone is
changed to prefix - 4345#. I don't see called number but just prefix.

Is any way to change this behavior ?

My configuration:
(dial-peer from HQ router to carrier)

voice translation-rule 4000
 rule 2 /^0)/ /4345#/ type any international plan any isdn
!
voice translation-profile ADDPREFIX
 translate called 4000
!
dial-peer voice 1003 voip
 translation-profile outgoing ADDPREFIX
 huntstop
 destination-pattern 0T
 progress_ind setup enable 3
 session protocol sipv2
 session target ipv4:x.x.x.x:5060
 dtmf-relay rtp-nte
 codec g711ulaw
 clid strip name
 no vad
!

(dial-peer between CUCME and HQ)

dial-peer voice 1000 voip
 huntstop
 destination-pattern 0T
 progress_ind setup enable 3
 session target ipv4:10.4.30.2
 dtmf-relay h245-alphanumeric
 codec g711ulaw
 ip qos dscp cs5 media
 clid strip name
 no vad
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20140203/0100ea74/attachment.html>