[cisco-voip] Anyone using the Cisco 300 Series switches? Unable to get

[Pawlowski, Adam]

The auto smartport and VLAN assignment doesn't work unless you have the auto smartport enabled (which you don't below) and the switch receives a CDP packet from the uplink which tells it what's up.

I was not a fan of smart port for these, and they are not supported in CER either.

Adam

Message: 18
Date: Wed, 21 May 2014 10:04:52 -0300
From: "Michel L. M. B. Perez" <michelmbperez at gmail.com>
To: Jeffrey Girard <jeffrey.girard at girardinc.com>
Cc: "Cisco VOIP \(cisco-voip at puck.nether.net\)"
	<cisco-voip at puck.nether.net>
Subject: Re: [cisco-voip] Anyone using the Cisco 300 Series switches?
	Unable to get Auto Voice VLAN to work
Message-ID:
	<CAGxpHypVMA6ZGRkDZTUwvu5RUM9xussBvwjAy6=vsVbaJvpLvA at mail.gmail.com>
Content-Type: text/plain; charset="utf-8"

The only that i found to make Voice VLAN work ate this device, is to map the beginning of MAC address of some phones that will be attached at this Switch. We are using at this customer 69XX series phones and CUCM 8.6.

This is the config:
!
voice vlan id 3
voice vlan state oui-enabled
voice vlan oui-table add 28940f CISCO___________________ voice vlan oui-table add 44d3ca CISCO___________________ voice vlan oui-table add 503de5 CISCO___________________ voice vlan oui-table add 649ef3 CISCO___________________ !
interface fastethernet1/2/1
 spanning-tree portfast
 switchport trunk native vlan XX (PC VLAN)  lldp optional-tlv port-desc sys-name sys-desc sys-cap 802.3-mac-phy 802.3-lag 802.3-max-frame-size  lldp med notifications topology-change enable  lldp med enable network-policy poe-pse  macro description ip_phone_desktop  voice vlan enable  voice vlan cos mode all  no macro auto smartport  !next command is internal.
 macro auto smartport dynamic_type unknown

--
Michel Perez
Skype: michelmbperez
michelmbperez at gmail.com
http://br.linkedin.com/in/michelmbperez