[cisco-voip] No ring back Tone For Switched off Mobile

[Sreekanth Narayanan (sreenara)]

This happens when the CUBE receives the prompt from the ITSP over RTP and is not aware of where it has to stream this prompt because CUCM does Delayed Offer by default. So Cube doesnt have the phone's IP address.

You can fix this by forcing CUCM to send provisional acknowöedgement by:
1. putting voice-class sip rel1xx require "100rel" on the dial peers facing CUCM, and
2. Under sip profile of sip trunk facing CUBE, change the Rel1xx parameter to Send Prack for all 1xx messages.



Sreekanth

Sent from a phone.


-------- Original message --------
From: Asim Mekki Basheer <asim_323 at hotmail.com>
Date: 5/23/16 4:37 PM (GMT+05:30)
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] No ring back Tone For Switched off Mobile


Hi


The issue is, when call out to a Switched off mobile phone, the IP Phone can't hear the correct ringback tone either Busy Tone nor Service Provider's Ringtone, it hears normal Ringback tone same as when the mobile phone switched on instead

The call flow:

IP Phone -- CUCM -- SIP Trunk--  CUBE --SIP Trunk -- Service Provider .


(CUCM 7.5,  VGW (2921)


Regards
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20160523/357d6794/attachment.html>