[cisco-voip] CER 9.x and SNMP

[Brian Meade]

No, you don't need SNMP configuration for the switches but you will need
SNMP to CUCM so it can pull the phone IP addresses.

You can also enable "Use IP Address from call signaling" on the Telephony
Settings in CER so that it uses the IP from the call signaling rather than
the periodic SNMP pulls from CUCM.

On Wed, Oct 26, 2016 at 7:58 AM, Jason Aarons (AM) <
jason.aarons at dimensiondata.com> wrote:

>
>
> If using IP Subnet based ERLs,  is SNMP to switches required for Emergency
> Responder 9.0?  Alerts appear to be working and snmp is blocked via
> firewall (I suspect) to switches.
>
>
>
> ERL Membership > IP subnets
>
>
>
> http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cer/9_0/
> english/administration/guide/CER0_BK_CBC9B8B3_00_cisco-
> emergency-responder-admin-guide/CER0_BK_CBC9B8B3_00_
> cisco-emergency-responder-admin-guide_chapter_0100.html#
> CER0_TK_S41D598F_00
>
>
>
>
>
>
>
>
>
>
>
>
> This email and all contents are subject to the following disclaimer:
> "http://www.dimensiondata.com/emaildisclaimer"
> <http://www.dimensiondata.com/Global/Policies/Pages/Email-Disclaimer.aspx>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20161026/ac9053e2/attachment.html>