[cisco-voip] 8845's cannot make outbound calls
Ryan Huff
ryanhuff at outlook.com
Fri Mar 31 15:26:14 EDT 2017
conf t
(config)# voice-port0/0/0:23
(config-voiceport)# bearer-cap speech
exit
wr mem
Sent from my iPhone
On Mar 31, 2017, at 2:52 PM, Nick Britt <nickolasjbritt at gmail.com<mailto:nickolasjbritt at gmail.com>> wrote:
Just ran into this one....
Topology:
8845 > CUCM 8.6 > H323 GW > T1 > PSTN
Desc of problem: Video capable handsets cannot make outbound calls where as non video phones work fine. Calls are passed to h323 GW OK
Troubleshooting steps:
Devices have same Class of service/device pool/within subnet
Config:
voice-port 0/0/0:23
!
interface Serial0/0/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
isdn supp-service name calling
isdn outgoing display-ie
trunk-group PRI-TGroup
no cdp enable
Debugs:
Failed Call
Bearer Capability i = 0x8890
Standard = CCITT
Transfer Capability = Unrestricted Digital
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98383
Exclusive, Channel 3
Facility i = 0x9F8B0100A117020172020100800F41647669736F7273202D2032333635
Protocol Profile = Networking Extensions
0xA117020172020100800F41647669736F7273202D2032333635
Component = Invoke component
Invoke Id = 114
Operation = CallingName
Name Presentation Allowed Extended
Name = Advisors -
Display i = 'Advisors - 2365'
Calling Party Number i = 0x2181, 'REMOVED (same as working handset)'
Plan:ISDN, Type:National
Called Party Number i = 0xA1, '(same as working call)'
Plan:ISDN, Type:National
1968093: Mar 30 11:50:16.112 NDT: ISDN Se0/0/0:23 Q931: RX <- STATUS pd = 8 callref = 0xFD71
Cause i = 0x82E3 - Information element not implemented
Call State i = 0x01
1968094: Mar 30 11:50:16.184 NDT: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8 callref = 0xFD71
Channel ID i = 0xA98383
Exclusive, Channel 3
1968097: Mar 30 11:50:23.824 NDT: ISDN Se0/0/0:23 Q931: pak_private_number: Invalid type/plan 0x0 0x0 may be overriden; sw-type 13
1968098: Mar 30 11:50:23.824 NDT: ISDN Se0/0/0:23 Q931: pak_private_number: Invalid type/plan 0x0 0x0 may be overriden; sw-type 13
1968099: Mar 30 11:50:23.824 NDT: ISDN Se0/0/0:23 Q931: Sending SETUP callref = 0x7D72 callID = 0xFC78 switch = primary-ni interface = User
1968100: Mar 30 11:50:23.824 NDT: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8 callref = 0x7D72
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98386
Exclusive, Channel 6
Facility i = 0x9F8B0100A122020173020100801A4E6172696E646572204B617572205369646875202D2032333433
Protocol Profile = Networking Extensions
0xA122020173020100801A4E6172696E646572204B617572205369646875202D2032333433
Component = Invoke component
Invoke Id = 115
Operation = CallingName
Name Presentation Allowed Extended
Name =
Display i = ''
Calling Party Number i = 0x2181, 'REMOVED (same as working handset) '
Plan:ISDN, Type:National
Called Party Number i = 0xA1, '(same as failed call) '
Plan:ISDN, Type:National
1968101: Mar 30 11:50:23.912 NDT: ISDN Se0/0/0:23 Q931: RX <- STATUS pd = 8 callref = 0xFD72
Cause i = 0x82E3 - Information element not implemented
Call State i = 0x01
1968102: Mar 30 11:50:23.952 NDT: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8 callref = 0xFD72
Channel ID i = 0xA98386
Exclusive, Channel 6
1968103: Mar 30 11:50:24.748 NDT: %SSH-5-SSH2_SESSION: SSH2 Session request from 61.177.172.60 (tty = 1) using crypto cipher 'aes256-cbc', hmac 'hmac-sha1' Succeeded
1968104: Mar 30 11:50:26.560 NDT: ISDN Se0/0/0:23 Q931: RX <- PROGRESS pd = 8 callref = 0xFD71
Progress Ind i = 0x8488 - In-band info or appropriate now available
1968105: Mar 30 11:50:27.468 NDT: ISDN Se0/0/0:23 Q931: RX <- ALERTING pd = 8 callref = 0xFD72
Progress Ind i = 0x8488 - In-band info or appropriate now available
1968106: Mar 30 11:50:28.460 NDT: ISDN Se0/0/0:23 Q931: RX <- DISCONNECT pd = 8 callref = 0xFD71
Cause i = 0x80D8 - Incompatible destination
Resolution:
Video handsets are sending Transfer Capability = Unrestricted Digital where as non video handsets are sending the transfer capability = speech
Fix
Disable video on handsets
or
implement on the t1 voice port
voice-port 0/0/0:23
bearer-cap Speech
More info:
https://supportforums.cisco.com/discussion/11381081/outgoing-call-problem-new-series-ipt
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20170331/583fff68/attachment.html>
More information about the cisco-voip
mailing list