hi<BR><BR>i have a as5350 whit 4 dial-peer working (3 for outbound calls and
1 for inbound calls), the as5350 is connected to a switch using 2E1 whit r2
signaling as the summary of the config below<BR><BR>dial-peer voice 1000
voip<BR> destination-pattern 1..........<BR> voice-class codec
100<BR> session target
ipv4:x.x.x.x<BR> tech-prefix 12<BR> dtmf-relay
h245-alphanumeric<BR> no vad<BR>!<BR>dial-peer voice 2000
voip<BR> destination-pattern 54..........<BR> voice-class codec
100<BR> session target
ipv4:x.x.x.x<BR> tech-prefix 25<BR> dtmf-relay
h245-alphanumeric<BR> no vad<BR>!<BR>dial-peer voice 2000
voip<BR> destination-pattern 44..........<BR> voice-class codec
100<BR> session target
ipv4:x.x.x.x<BR> tech-prefix 45<BR> dtmf-relay
h245-alphanumeric<BR> no vad<BR>!<BR>dial-peer voice 4000
pots<BR> destination-pattern 010[2,6].....<BR> port
3/2:1<BR> forward-digits 5<BR>!<BR><BR><BR>i will add a 5th dial-peer,
this is for inbound traffic, but now i need to differenciate the traffic
beetween both inboud prividers, i'm not using syslog or radius logs, i'm
using the CDR of the 2E1 attached switch, so i ask if it is posible to put a
fix ani for each dial-peer on the as5350 ?<BR>do i need to use tranlations
?<BR>I'm thinking that the solution could be modify the caller id or ANI
before the call is send to the E1 for termination.<BR><BR>this is the new
dial-peer<BR><BR>dial-peer voice 5000 pots<BR> destination-pattern
011[2,6].....<BR> port 3/2:1<BR> forward-digits 5<BR>!<BR><BR>any
advice ?<BR>thanks<BR><BR>seedorf