<HTML dir=ltr><HEAD></HEAD>
<BODY>
<DIV><FONT face=Arial color=#000000 size=2>All,</FONT></DIV>
<DIV> </DIV>
<DIV><FONT face=Arial size=2>I have a question about setup a shared line on both port of a ATA186.</FONT></DIV>
<DIV> </DIV>
<DIV><FONT face=Arial size=2>CCM version is 4.1.3sr3a</FONT></DIV>
<DIV> </DIV>
<DIV><FONT face=Arial size=2>Load for the ATA is: </FONT> ATA030203SCCP051201A</DIV>
<DIV> </DIV>
<DIV><FONT face=Arial size=2>Codec will be 711 on both ports with no possibilty of needing to xcode.</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>The reason is that I am setting up an overhead ringer on a Bogen Amp that has a bell input. I am not sure if I can dasey-chain the two amps together off of one ATA port. If i can, then i will just use one port and nevermind then :)</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>Thanks.</FONT></DIV>
<DIV><P><HR>
This message and any attachments are intended only for the use of the addressee and may contain information that is privileged and confidential. If the reader of the message is not the intended recipient or an authorized representative of the intended recipient, you are hereby notified that any dissemination of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail and delete the message and any attachments from your system.
</P></DIV>
</BODY></HTML>