I checked again, and that subnet has a /22 on it, so it covers the entire region...<br><br>I ran the debugs and saw this:<br><br><br>value RasMessage ::= registrationReject :<br>&nbsp;&nbsp;&nbsp; {<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; requestSeqNum 47<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; protocolIdentifier { 0 0 8 2250 0 4 }
<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; rejectReason discoveryRequired : NULL<br>&nbsp;&nbsp;&nbsp; }<br><br><br><br><br>Jonathan<br><br><div><span class="gmail_quote">On 10/30/06, <b class="gmail_sendername">Ryan Ratliff</b> &lt;<a href="mailto:rratliff@cisco.com">
rratliff@cisco.com</a>&gt; wrote:</span><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">Check that zone subnet command.&nbsp;&nbsp;I'm pretty sure it restricts what IP
<br>addresses the gatekeeper will allow registration from.&nbsp;&nbsp;Also check<br>out 'debug ras', 'debug h225 asn1', and 'debug gatek main 10'.<br><br>-Ryan<br><br>On Oct 30, 2006, at 1:52 PM, Jonathan Charles wrote:<br><br>There is a route-pattern pointing to the trunk, but the Gatekeeper
<br>only shows the MCU registered as an endpoint.<br><br>The CM is set to register as a gateway... and the CM is not on the<br>same subnet...<br><br><br><br>Jonathan<br><br>On 10/30/06, Ryan Ratliff &lt;<a href="mailto:rratliff@cisco.com">
rratliff@cisco.com</a>&gt; wrote: You have to<br>have a route pattern pointing to the trunk for CM to<br>register with the gk afaik.&nbsp;&nbsp;Also note that CM only retries<br>registration every 30-60 seconds.&nbsp;&nbsp;For quicker results reset the gk-
<br>controlled trunk.&nbsp;&nbsp;Also make sure you have CM set to register as a<br>gateway not a terminal.<br><br> From your config I assume CM's IP address falls within the<br><a href="http://10.1.1.0/22">10.1.1.0/22</a> subnet?<br>
<br>-Ryan<br><br>On Oct 30, 2006, at 12:38 PM, Jonathan Charles wrote:<br><br>OK, I have a CCM4.1 box, and I am trying to get it to connect (for<br>video) to a Cisco MCU, via a gatekeeper...<br><br>The MCU is registered to the gatekeeper as an endpoint, but I can't
<br>get the CCM to do the same...<br><br>I have a gatekeeper controlled trunk pointing at the MCU (with the GK<br>identified)...<br><br>Still nothing...<br><br>I also added a couple of route-patterns (with the MCU service
<br>prefixes) pointing at the trunk... Still nothing...<br><br><br>gatekeeper<br>&nbsp;&nbsp; zone local <a href="http://10.1.1.1">10.1.1.1</a> <a href="http://binky.com">binky.com</a><br>&nbsp;&nbsp; zone subnet <a href="http://10.1.1.1">10.1.1.1
</a> <a href="http://10.1.1.0/22">10.1.1.0/22</a> enable<br>&nbsp;&nbsp; zone prefix <a href="http://10.1.1.1">10.1.1.1</a> 2125554244*<br>&nbsp;&nbsp; gw-type-prefix 1#* default-technology<br>&nbsp;&nbsp; no shutdown<br><br><br><br>Any ideas?<br><br>
TIA<br><br><br><br>Jonathan<br>_______________________________________________<br>cisco-voip mailing list<br><a href="mailto:cisco-voip@puck.nether.net">cisco-voip@puck.nether.net</a><br><a href="https://puck.nether.net/mailman/listinfo/cisco-voip">
https://puck.nether.net/mailman/listinfo/cisco-voip</a><br><br></blockquote></div><br>