<div>Hello all,</div>
<div>&nbsp;</div>
<div>Users are having problem on analog phones connected to VG224 port and registered at CCM 5&nbsp;.</div>
<div>&nbsp;</div>
<div>Topology:</div>
<div>analog phone ----VG224</div>
<div>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; &nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;|</div>
<div>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; ---------callmanager 3845(FXO) outgoing and E1R2 for incomming call.</div>
<div>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; |</div>
<div>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; ---------3845(with FXO for outgoing and E1R2 DID for incomming call).</div>
<div>&nbsp;</div>
<div>Problems:</div>
<div>1&gt;analog phone A calling Analog Phone B. If phone A hangs up after the call, Phone B gets disconnected with &quot;your phone can&#39;t be completed as dialed&quot;.</div>
<div>&nbsp;</div>
<div>2&gt;When phone is off hook then user dials, and puts the phone on hook, it takes some time to wait before dial tone appears again.</div>
<div>&nbsp;</div>
<div>3&gt;There is a fax machine that needs to forward calls using hookflash. configured CCM 5&nbsp; with 2 maximum lines but when hookflash pressed, nothing happens....after 3-4 press of flash button call on the called party gets disconnected.
</div>
<div>&nbsp;</div>
<div>4&gt; Users doing phone banking system is having failure entering his/her pin on the analog phone. Is the dtmf-relay needed to be configured on FXO port? can&#39;t seem to find&nbsp;the command on the pots dialer peer.</div>

<div>&nbsp;</div>
<div>voice-port 2/0<br>&nbsp;cptone PH<br>!<br>:</div>
<div>sccp local FastEthernet0/0<br>sccp ccm <a href="http://137.178.1.70">137.178.1.70</a> identifier 2<br>sccp ccm <a href="http://137.177.21.70">137.177.21.70</a> identifier 1<br>sccp<br>!<br>sccp ccm group 2<br>&nbsp;associate ccm 1 priority 2
<br>&nbsp;associate ccm 2 priority 1<br>!<br>dial-peer voice 323 pots<br>&nbsp;service stcap<br>&nbsp;port 2/0<br>!</div>
<div>&nbsp;</div>
<div>Is there any fine tuning parameters that i could use to solve the above problems? These analog phones are connected to a nortel pbx system before without any problems and i got to prove that it works on cisco devices as well.
</div>
<div>&nbsp;</div>
<div>Thanks in advance!</div>
<div>&nbsp;</div>
<div>Cheers,</div>
<div>Jeff</div>
<div>&nbsp;</div>
<div>&nbsp;</div>