<div>Hi to All,</div>
<div> </div>
<div>I'm using a CME and one external gateway for outgoing calls, this gateway only is a H.323 terminal, and all work fine. Rightnow I need configure the gateway (Cisco 2611XM with E1 Card) for incoming calls, I thought that it will be easier but unfortunately, so far the conf donīt work...
</div>
<div> </div>
<div>I put into gateway:</div>
<div> </div>
<div>dial-peer voice 500 voip<br> destination-pattern 45..<br> session target ipv4:<a href="http://192.168.200.45">192.168.200.45</a><br>!<br clear="all"></div>
<div>but after, my outgoing calls don't proceed (neither incoming calls). the IP <a href="http://192.168.200.45">192.168.200.45</a> is my CME and 45xx are the internal extensions. The internal extensions 45xx work fine with CME and can do calls via the gateway (I have other PRI into CME for regular calls, here all work fine).
</div>
<div> </div>
<div>Just in case, the external device (a older PBX) provide 4 digits in 45xx format and it is connected to Gateway via E1. Also all devices Gateway and CME are in the same LAN.</div>
<div> </div>
<div>Pls any suggestions will be appreciate...</div>
<div> </div>
<div>Rgds.</div>
<div> </div>
<div>-- <br>Omar E.P.T<br>-----------------<br>Certified Networking Professionals make better Connections!<br><br> </div>