<div>If you need features with fxs&nbsp;you might want to look into SCCP for FXS controller as you would with a VG224 and h323 for and PSTN/PRI access etc. (see the link you need CM4.2+ and a certain rev of IOS depending on your hardware). 
</div>
<div>&nbsp;</div>
<div><a href="http://www.cisco.com/en/US/partner/products/ps6441/products_feature_guide09186a0080483a76.html#wp1304455">http://www.cisco.com/en/US/partner/products/ps6441/products_feature_guide09186a0080483a76.html#wp1304455
</a></div>
<div>&nbsp;</div>
<div><a href="http://www.cisco.com/en/US/products/ps6706/products_feature_guide09186a00806cab75.html#wp1049404"></a>&nbsp;</div>
<div>&nbsp;</div>
<div><br><br>&nbsp;</div>
<div><span class="gmail_quote">On 9/20/07, <b class="gmail_sendername">Cucumber Green</b> &lt;<a href="mailto:greencucumber2007@yahoo.com">greencucumber2007@yahoo.com</a>&gt; wrote:</span>
<blockquote class="gmail_quote" style="PADDING-LEFT: 1ex; MARGIN: 0px 0px 0px 0.8ex; BORDER-LEFT: #ccc 1px solid">
<div>Hello!</div>
<div>&nbsp;</div>
<div>Yeah I have tried this without luck, I guess it only works if the H323 gateway has a FXO</div>
<div>connection to a PBX<span class="q"><br><br><b><i>Robert Schuknecht &lt;<a onclick="return top.js.OpenExtLink(window,event,this)" href="mailto:rschuknecht@gmx.de" target="_blank">rschuknecht@gmx.de</a>&gt;</i></b> wrote:
</span></div>
<blockquote style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #1010ff 2px solid"><span class="q">Hi Cucumber,<br><br>did you try to adjust the the hook-flash timer under the voice-port?<br>This timer has to equal on the voice-port and the connected telephone.
<br><br>/Robert<br><br></span>&gt;&gt;&gt; Cucumber Green schrieb am Donnerstag, 20. 
<div><span class="e" id="q_11525a5536d10d4c_5"><br>September 2007 um 17:53 in Nachricht 3ab0adee131ef58c7afb0ea50017a410:<br>&gt; Analog phones can send and receive calls from IP phones, but<br>&gt; when pressing the hookflash key at the analog phone, the analog phone does 
<br>&gt; not get a dial tone in order to transfer the call :(<br>&gt; <br>&gt; Phones are hooked into FXS ports on a 2811 and will use G729 codec.<br>&gt; <br>&gt; I have already checked the &quot;Media Termination Point required&quot; check box in 
<br>&gt; the gateway configuration at call manager (using unified call manager 4.2(3) <br>&gt; ). I thought that would do the trick, but it didnt, any ideas?<br>&gt; <br>&gt; This is the gateway config (IOS version 12.4(3g) spservicesK9)
<br>&gt; <br>&gt; !<br>&gt; version 12.4<br>&gt; service timestamps debug datetime msec<br>&gt; service timestamps log datetime msec<br>&gt; service password-encryption<br>&gt; !<br>&gt; ip subnet-zero<br>&gt; !<br>&gt; !
<br>&gt; ip cef<br>&gt; !<br>&gt; !<br>&gt; no ip domain lookup<br>&gt; !<br>&gt; voice-card 0<br>&gt; no dspfarm<br>&gt; !<br>&gt; !<br>&gt; !<br>&gt; !<br>&gt; interface Loopback0<br>&gt; ip address X.X.X.X <a onclick="return top.js.OpenExtLink(window,event,this)" href="http://255.255.255.255/" target="_blank">
255.255.255.255</a><br>&gt; h323-gateway voip bind srcaddr X.X.X.X<br>&gt; !<br>&gt; !<br>&gt; ip classless<br>&gt; ip route <a onclick="return top.js.OpenExtLink(window,event,this)" href="http://0.0.0.0/" target="_blank">
0.0.0.0</a> <a onclick="return top.js.OpenExtLink(window,event,this)" href="http://0.0.0.0/" target="_blank">0.0.0.0</a> X.X.X.X 254<br>&gt; !<br>&gt; !<br>&gt; control-plane<br>&gt; !<br>&gt; !<br>&gt; !<br>&gt; voice-port 0/1/0
<br>&gt; signal loopStart<br>&gt; !<br>&gt; voice-port 0/1/1<br>&gt; signal loopStart<br>&gt; !<br>&gt; dial-peer voice 10 pots<br>&gt; destination-pattern 50001<br>&gt; port 0/1/0<br>&gt; !<br>&gt; dial-peer voice 20 pots
<br>&gt; destination-pattern 50002<br>&gt; port 0/1/1<br>&gt; !<br>&gt; dial-peer voice 1 voip<br>&gt; preference 1<br>&gt; destination-pattern 1...<br>&gt; session target ipv4:X.X.X.X<br>&gt; dtmf-relay h245-alphanumeric
<br>&gt; codec g729r8 bytes 40<br>&gt; ip qos dscp cs3 media<br>&gt; ip qos dscp cs3 signaling<br>&gt; !<br>&gt; dial-peer voice 4 voip<br>&gt; preference 2<br>&gt; destination-pattern 1...<br>&gt; session target ipv4:X.X.X.X
<br>&gt; dtmf-relay h245-alphanumeric<br>&gt; codec g729r8 bytes 40<br>&gt; ip qos dscp cs3 media<br>&gt; ip qos dscp cs3 signaling<br>&gt; !<br>&gt; <br>&gt; <br>&gt; <br>&gt; ---------------------------------<br>&gt; Be a better Globetrotter. Get better travel answers from someone who knows.
<br>&gt; Yahoo! Answers - Check it out.<br></span></div></blockquote><span class="ad"><br>
<p>
<hr size="1">
Don&#39;t let your dream ride pass you by. <a onclick="return top.js.OpenExtLink(window,event,this)" href="http://us.rd.yahoo.com/evt=51200/*http://autos.yahoo.com/index.html;_ylc=X3oDMTFibjNlcHF0BF9TAzk3MTA3MDc2BHNlYwNtYWlsdGFncwRzbGsDYXV0b3MtZHJlYW1jYXI-" target="_blank">
Make it a reality</a> with Yahoo! Autos. 
<p></p></p></span><br>_______________________________________________<br>cisco-voip mailing list<br><a onclick="return top.js.OpenExtLink(window,event,this)" href="mailto:cisco-voip@puck.nether.net">cisco-voip@puck.nether.net
</a><br><a onclick="return top.js.OpenExtLink(window,event,this)" href="https://puck.nether.net/mailman/listinfo/cisco-voip" target="_blank">https://puck.nether.net/mailman/listinfo/cisco-voip</a><br></blockquote></div><br>