<br><font size=2 face="sans-serif">Can anyone verify Robert's suggested
IOS version for inbound Caller ID to work on H.323? What additional
commands on the gateway and Call Mgr config are needed?</font>
<br>
<br><font size=2 face="sans-serif">Carlos</font>
<br>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td width=40%><font size=1 face="sans-serif"><b>Robert Kulagowski <rkulagow@gmail.com></b>
</font>
<p><font size=1 face="sans-serif">09/14/2007 11:30 AM</font>
<td width=59%>
<table width=100%>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">To</font></div>
<td><font size=1 face="sans-serif">CarlosOrtiz@bayviewfinancial.com</font>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">cc</font></div>
<td><font size=1 face="sans-serif">cisco-voip@puck.nether.net</font>
<tr valign=top>
<td>
<div align=right><font size=1 face="sans-serif">Subject</font></div>
<td><font size=1 face="sans-serif">Re: [cisco-voip] Inbound Caller ID NAME</font></table>
<br>
<table>
<tr valign=top>
<td>
<td></table>
<br></table>
<br>
<br>
<br><font size=2><tt>> I was looking through the archives and it seems
that to get inbound <br>
> caller ID NAME to work you MUST:<br>
> <br>
> 1) Use MGCP<br>
> 2) Enable NI2 protocol<br>
> <br>
> Is this still the case? Did I miss anything else?<br>
<br>
Check the archives a little more! :)<br>
<br>
We just discussed this not too long ago.<br>
<br>
You can use H.323: either use the cname tcl script that was written by
<br>
David Zilk or the IOS that has this built-in. 12.4.11XU?<br>
</tt></font>
<br>