Hi All,<br>
I am having a physical layer problem in integrating the Avaya G3 Si V8
with Cisco Router 2811. The problem when i connect the PBX through the
E1 connection with the router the E1 interface is down without
any alarm, what i can see is Line Code Voilations and Path Code
Violations on the router and from the PBX side the interface is sync
but is not in IDLE mode or you can say it will not accept any calls. I
have hard loped both PBX and router in the middle from which they are
connecting hardloping makes the E1 interface UP and also make PBX
able to attend calls, but when i join them problem arises.The router
has two port E1 G.703 card. Is there any one who can help me out in
this regard. <br clear="all"><br>-- <br>Regards,<br>Zohaib Shabir<br>Network Engineer(Voice)<br>DWP Group, TECH Division Karachi<br>Ph:+92-302-8232689