<div>Hey Guys,</div>
<div> </div>
<div>I seem to have hit a stumbling block setting up a RightFax server V9.3 and a Brooktrout TR1034 card.</div>
<div>I cant get the T-1 to come up.</div>
<div>The way its set up is the BrookTrout card goes to a VWIC2-2MFT-T1/E1-T1 port on my 2851.</div>
<div>I am using CUCM 5.1.1 and MGCP on that T1 port on the 2851. My config on the 2851 is as follows.</div>
<div> </div>
<div>controller T1 0/1/1<br> framing esf<br> clock source internal<br> linecode b8zs<br> pri-group timeslots 1-24 service mgcp<br>!</div>
<div> </div>
<div>interface Serial0/1/1:23<br> no ip address<br> isdn switch-type primary-4ess<br> isdn protocol-emulate network<br> isdn incoming-voice voice<br> isdn bind-l3 ccm-manager<br> no cdp enable</div>
<div> </div>
<div> </div>
<div>On the Brooktrout card on the "PortA" tab I have the following:</div>
<div>Switch Type : AT&T #4 ESS</div>
<div>Protocol (Variant): Bellcore national ISDN-1 Standard</div>
<div>Emulation: CPE</div>
<div>Line Coding B8ZS</div>
<div> </div>
<div>On the "Clock settings" tab i have:</div>
<div>Clock Mode: Master</div>
<div>Clock Source : Network Trunk Port A</div>
<div>Clock Compatibility: None</div>
<div> </div>
<div> </div>
<div>I tried getting their Tech support to help but they pointed fingers at the CUCM and said they couldnt help me any further.</div>
<div> </div>
<div>Thanks,</div>
<div> </div>
<div>Joel P</div>
<div> </div>