<br><font size=2 face="sans-serif">We had a location with a PRI experience
an issue yesterday. &nbsp;Layer 1-3 status was good. &nbsp;It appears that
the 1st B channel was in a stuck state. &nbsp;Inbound and outbound calls
were both set up to use low to high channels. After running the &quot;show
voice call summary&quot; I would see the following output and the status
would not change.</font>
<br>
<br><font size=2 color=red face="sans-serif"><b>PORT &nbsp; &nbsp; &nbsp;
&nbsp; &nbsp; CODEC &nbsp; &nbsp;VAD VTSP STATE &nbsp; &nbsp; &nbsp; &nbsp;
&nbsp; &nbsp;VPM STATE</b></font>
<br><font size=2 color=red face="sans-serif"><b>============== ========
=== ==================== ======================</b></font>
<br><font size=2 color=red face="sans-serif"><b>0/0/1:23.1 &nbsp; &nbsp;
&nbsp;g711ulaw &nbsp;n &nbsp;S_WAIT_STATS &nbsp; &nbsp; &nbsp; &nbsp; &nbsp;S_TSP_WAIT_RELEASE
&nbsp; &nbsp; </b>&nbsp;</font>
<br>
<br>
<br><font size=2 face="sans-serif">After changing outbound calls to high
to low the outbound calls started working again. &nbsp;This lead me to
believe that there was some kind of hardware/DSP or software issue. &nbsp;
I tried a shut no shut on the voice port and the controller but that did
not fix the inbound problem. &nbsp;A reboot did fix the issue.</font>
<br>
<br><font size=2 face="sans-serif">Anyone seen something similar?</font>
<br>
<br><font size=2 face="sans-serif">Carlos</font>