<HTML>
<HEAD>
<TITLE>Re: [cisco-voip] VoIP over Hardware VPN</TITLE>
</HEAD>
<BODY>
<FONT SIZE="4"><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:14.0px'><B>Doing PAT on both firewalls.<BR>
</B></SPAN></FONT></FONT><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:12.0px'><BR>
<BR>
On 5/28/09 3:48 PM, "Wes Sisk" <wsisk@cisco.com> wrote:<BR>
<BR>
</SPAN></FONT><BLOCKQUOTE><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:12.0px'>It depends on your setup. If you are doing address translation then you must have it enabled.<BR>
<BR>
If you are not doing address translation and do not dynamic port allocation (basically if you have permit ip any any) then you need to have it disabled.<BR>
<BR>
So, engineer's favorite answer - it depends.<BR>
<BR>
/Wes<BR>
<BR>
On Thursday, May 28, 2009 3:56:48 PM, Jim Reed <jreed@swiftnews.com> <a href="mailto:jreed@swiftnews.com"><mailto:jreed@swiftnews.com></a> wrote:<BR>
</SPAN></FONT><BLOCKQUOTE><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:12.0px'> Re: [cisco-voip] VoIP over Hardware VPN </SPAN><FONT SIZE="4"><SPAN STYLE='font-size:14.0px'><B>Thanks, Lelio.<BR>
Are you referring to turning it on or turning it off!<BR>
</B></SPAN></FONT><FONT SIZE="2"><SPAN STYLE='font-size:10.0px'>-- <BR>
Jim Reed<BR>
Swift Communications, Inc.<BR>
970-683-5646 (Direct)<BR>
775-772-7666 (Cell)<BR>
<BR>
<BR>
</SPAN></FONT><SPAN STYLE='font-size:12.0px'> <BR>
On 5/28/09 1:55 PM, "Lelio Fulgenzi" <lelio@uoguelph.ca> <a href="mailto:lelio@uoguelph.ca"><mailto:lelio@uoguelph.ca></a> wrote:<BR>
<BR>
<BR>
</SPAN></FONT><BLOCKQUOTE><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:12.0px'>I think the biggest thing is "sccp fixup"....<BR>
<BR>
---<BR>
Lelio Fulgenzi, B.A.<BR>
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1<BR>
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)<BR>
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^<BR>
"Bad grammar makes me [sic]" - Tshirt<BR>
<BR>
<BR>
----- Original Message -----<BR>
From: "Jim Reed" <jreed@swiftnews.com> <a href="mailto:jreed@swiftnews.com"><mailto:jreed@swiftnews.com></a> <BR>
To: cisco-voip@puck.nether.net, ask-icd-ivr-support@external.cisco.com<BR>
Sent: Thursday, May 28, 2009 3:44:45 PM GMT -05:00 US/Canada Eastern<BR>
Subject: [cisco-voip] VoIP over Hardware VPN<BR>
<BR>
VoIP over Hardware VPN </SPAN><FONT SIZE="4"><SPAN STYLE='font-size:14.0px'><B>Anyone have any hints, tips, suggestions, comments, concerns, etc., regarding running a single IP phone over a hardware-to-hardware VPN. I've tried it in the past but could only seem to get voice going in one direction. It's been a while and I'm going to give it another shot. Will be working with ASA 5505 on one and ASA 5510 on the other. Call Manager 4.x. Probably a 7940 or 7960 phone. Internet connections are 15-Meg-Over-Ethernet on one end and 10-Meg-Over-Ethernet on the other. Current ping times between devices on the two ends are consistently very fast -- less than 100ms over extended ping tests.<BR>
<BR>
Any advice, anecdotal wisdom, personal experience, etc., that anyone has had in trying to do this is sincerely welcome and appreciated.<BR>
<BR>
Thank You...<BR>
<BR>
</B></SPAN></FONT></FONT></BLOCKQUOTE><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:12.0px'> <BR>
</SPAN><FONT SIZE="2"><SPAN STYLE='font-size:10.0px'> </SPAN></FONT><SPAN STYLE='font-size:12.0px'> <BR>
<BR>
<HR ALIGN=CENTER SIZE="4" WIDTH="90%"><BR>
_______________________________________________<BR>
cisco-voip mailing list<BR>
cisco-voip@puck.nether.net<BR>
https://puck.nether.net/mailman/listinfo/cisco-voip<BR>
<BR>
</SPAN></FONT></BLOCKQUOTE><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:12.0px'><BR>
<BR>
</SPAN></FONT></BLOCKQUOTE><FONT FACE="Verdana, Helvetica, Arial"><SPAN STYLE='font-size:12.0px'><BR>
<BR>
-- <BR>
Jim Reed<BR>
Swift Communications, Inc.<BR>
970-683-5646 (Direct)<BR>
775-772-7666 (Cell)<BR>
<BR>
</SPAN></FONT>
</BODY>
</HTML>