<div>Hello</div>
<div> </div>
<div>I am trying to configure a sip trunk to voicepulse but seem to not be having much luck.  When I called into voicepulse they told me they see my sip register requests and they respond back asking for credentals but they are never sent I just keep sending requests  My config is as follows</div>

<div> </div>
<div> </div>
<div><br>ip name-server 10.1.80.2<br>ip name-server 10.1.80.3<br>ip inspect udp idle-time 1800<br>ip inspect name CBAC tcp<br>ip inspect name CBAC udp<br>ip inspect name CBAC icmp</div>
<div><br>voice service voip<br> callmonitor<br> allow-connections h323 to sip<br> allow-connections sip to h323<br> allow-connections sip to sip<br> fax protocol pass-through g711ulaw<br> sip<br>!</div>
<div>sip-ua<br> credentials username ***removed****   password 7 ***removed****   realm <a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a><br> authentication username ***removed****  password 7 ***removed****  realm <a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a><br>
 registrar dns:<a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a> expires 3600<br> sip-server dns:<a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a><br> connection-reuse<br>
!</div>
<div> </div>
<div>interface GigabitEthernet0/0<br> bandwidth 30000<br> ip address 173.14.220.57 255.255.255.248<br> ip access-group internet in<br> no ip redirects<br> no ip unreachables<br> no ip proxy-arp<br> ip nbar protocol-discovery<br>
 ip flow ingress<br> ip flow egress<br> ip nat outside<br> ip inspect CBAC out<br> ip virtual-reassembly<br> duplex auto<br> speed auto</div>
<div> </div>
<div> </div>Cisco2821#sh si reg st<br>Line          peer           expires(sec)  registered   P-Associated-URI<br>============  =============  ============  ===========  ================<br>***removed****                      -1          2829          yes<br>
Cisco2821#sh si reg st<br>Line          peer           expires(sec)  registered   P-Associated-URI<br>============  =============  ============  ===========  ================<br>***removed****                       -1          2826          yes<br>
Cisco2821#sh si reg st<br>Line          peer           expires(sec)  registered   P-Associated-URI<br>============  =============  ============  ===========  ================<br>***removed****                       -1          2653          yes 
<div> </div>
<div>Translating &quot;<a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a>&quot;...domain server (10.1.80.2)</div>
<div>Translating &quot;<a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a>&quot;...domain server (10.1.80.2) [OK]</div>
<div>Translating &quot;<a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a>&quot;...domain server (10.1.80.2) [OK]</div>
<div>Translating &quot;<a href="http://jfk-primary.voicepulse.com">jfk-primary.voicepulse.com</a>&quot;...domain server (10.1.80.2) [OK]</div>
<div>Type escape sequence to abort.<br>Sending 5, 100-byte ICMP Echos to 64.61.93.190, timeout is 2 seconds:<br>!!!!!<br>Success rate is 100 percent (5/5), round-trip min/avg/max = 48/51/52 ms<br>Cisco2821#</div>
<div> </div>
<div> </div>
<div>any ideas?</div>