<html dir="ltr"><head>
<meta http-equiv="Content-Type" content="text/html; charset=iso-8859-1">
<meta content="MSHTML 6.00.5730.13" name="GENERATOR">
<style title="owaParaStyle"><!--P {
MARGIN-TOP: 0px; MARGIN-BOTTOM: 0px
}
--></style>
</head>
<body ocsi="x">
<div dir="ltr"><font face="Tahoma" color="#000000" size="2">Is there a Cisco Communications Manager controling the voicegateways? H.323 support for QSIG is very very limited, you need to run the gateways with MGCP, and you'll get much better results with QSIG.</font></div>
<div dir="ltr"><font face="tahoma" size="2"></font> </div>
<div dir="ltr"><font face="tahoma" size="2">-Nate</font></div>
<div id="divRpF635463" style="DIRECTION: ltr">
<hr tabindex="-1">
<font face="Tahoma" size="2"><b>From:</b> cisco-voip-bounces@puck.nether.net [cisco-voip-bounces@puck.nether.net] On Behalf Of Syed Khalid Ali [syed.khalid.khursheed@gmail.com]<br>
<b>Sent:</b> Sunday, November 01, 2009 1:39 AM<br>
<b>To:</b> cisco-voip@puck.nether.net<br>
<b>Subject:</b> [cisco-voip] Calling Name Issue with Nortel 11c and 61c with QSIG<br>
</font><br>
</div>
<div></div>
<div>Greeting:
<div><br>
</div>
<div>I have the following scenario. Two PBXes 11c and 61c. Both connected with Cisco Voice gateways as following:</div>
<div>11c----------------E1----------------VG1----------------VG2----------------61c</div>
<div>Calls are working fine but I could not able to get the Caller Name at each site. Both PBXes are acting the ISDN network side but QSIG.</div>
<div><br>
</div>
<div>11c has extension of 12XX and </div>
<div>61c has 2XXX, 3XXX, 4XXX</div>
<div><br>
</div>
<div>After looking at the command reference, I concluded that following commands should work: </div>
<div>isdn supp-service name calling</div>
<div>isdn outgoing display-ie</div>
<div><br>
</div>
<div>I did the following config on both sides:</div>
<div>
<div>interface Serial0/3/0:15</div>
<div> no ip address</div>
<div> no logging event link-status</div>
<div> isdn switch-type primary-qsig</div>
<div> isdn incoming-voice voice</div>
<div> isdn supp-service name calling</div>
<div> isdn send-alerting</div>
<div> isdn sending-complete</div>
<div> isdn outgoing display-ie</div>
<div> no cdp enable</div>
<div><br>
</div>
</div>
<div>but I am getting the following error message in Q931 debugs:</div>
<div>
<div>ISDN Se0/3/0:15 Q931: Applying typeplan for sw-type 0x16 is 0x0 0x1, Calling num</div>
<div> 1216</div>
<div>ISDN Se0/3/0:15 Q931: Applying typeplan for sw-type 0x16 is 0x0 0x9, Called num</div>
<div>0302</div>
<div>ISDN Se0/3/0:15 Q931: TX -> SETUP pd = 8 callref = 0x071A</div>
<div> Sending Complete</div>
<div> Bearer Capability i = 0x8090A3</div>
<div> Standard = CCITT</div>
<div> Transfer Capability = Speech</div>
<div> Transfer Mode = Circuit</div>
<div> Transfer Rate = 64 kbit/s</div>
<div> Channel ID i = 0xA9839F</div>
<div> Exclusive, Channel 31</div>
<div> Progress Ind i = 0x8183 - Origination address is non-ISDN</div>
<div> Calling Party Number i = 0x0180, '1216'</div>
<div> Plan:ISDN, Type:Unknown</div>
<div> Called Party Number i = 0x89, '0302'</div>
<div> Plan:Private, Type:Unknown</div>
<div> Locking Shift to Codeset 5</div>
<div> Codeset 5 IE 0x31 i = 0x80</div>
<div> Codeset 5 IE 0x32 i = 0x81</div>
<div>ISDN Se0/3/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0x871A</div>
<div> Channel ID i = 0xA9839F</div>
<div> Exclusive, Channel 31</div>
<div>ISDN Se0/3/0:15 Q931: RX <- ALERTING pd = 8 callref = 0x871A</div>
<div> Locking Shift to Codeset 5</div>
<div> Codeset 5 IE 0x32 i = 0x81</div>
<div><br>
</div>
<div> ISDN Se0/3/0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0x071A</div>
<div> Cause i = 0x8090 - Normal call clearing</div>
<div>ISDN Se0/3/0:15 Q931: RX <- CONNECT pd = 8 callref = 0x871A</div>
<div> Progress Ind i = 0x8182 - Destination address is non-ISDN</div>
<div> Connected Number i = 0x0080, '4446'</div>
<div> Locking Shift to Codeset 5</div>
<div> Codeset 5 IE 0x32 i = 0x81</div>
</div>
<div>
<div>ISDN Se0/3/0:15 **ERROR**: Ux_BadMsg: Invalid Message for call state 11, call id</div>
<div> 0x8E1D, call ref 0x71A, event 0x7</div>
<div>ISDN Se0/3/0:15 Q931: TX -> STATUS pd = 8 callref = 0x071A</div>
<div> Cause i = 0x80E507 - Message not compatible with call state</div>
<div> Call State i = 0x0B</div>
<div>
<div>ISDN Se0/3/0:15 Q931: RX <- RELEASE pd = 8 callref = 0x871A</div>
<div>ISDN Se0/3/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x071A</div>
</div>
</div>
<div><br>
</div>
<div>-- </div>
<div>Thanks,<br>
Syed Khalid Ali<br>
<br>
</div>
</div>
<DIV>
<p class=MsoNormal><span style='font-size:7.0pt';font-family:'"Helvetica","Tahoma","Arial","sans-serif"'><font color="#666666"><br><br> NOTICE: This email message is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message.</span><o:p></o:p></span></p><BR>
</DIV></body>
</html>