Thank you all for the these resources. I will definitely let you know if it worked or not. Right now I cannot do any testing with this system since it is already in production and they do not allow until testing is schedule in advance with approval.<div>
<br></div><div>Lastly any one the group know about this <span class="Apple-style-span" style="font-family: arial, sans-serif; font-size: 13px; border-collapse: collapse; ">**ERROR**: Ux_BadMsg:...... thing.</span></div><div>
<font class="Apple-style-span" face="arial, sans-serif"><span class="Apple-style-span" style="border-collapse: collapse;">I did a lot of googling but could not find any thing useful.<br></span></font><div><div><br>-- <br>
Regards,<br>Syed Khalid Ali</div><div><br><div class="gmail_quote">On Mon, Nov 2, 2009 at 1:31 PM, Tim Smith <span dir="ltr"><<a href="mailto:thsglobal@gmail.com">thsglobal@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">
<div>Another good one.</div><a href="http://www.cisco.com/en/US/solutions/collateral/ns340/ns517/ns477/ns296/white_paper_c11_459092.html" target="_blank">http://www.cisco.com/en/US/solutions/collateral/ns340/ns517/ns477/ns296/white_paper_c11_459092.html</a><div>
<div></div><div class="h5"><div>
<br><div><br><br><div class="gmail_quote">On Mon, Nov 2, 2009 at 7:30 PM, Tim Smith <span dir="ltr"><<a href="mailto:thsglobal@gmail.com" target="_blank">thsglobal@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
Are there other dial peers on the VG's? or are is the connection purely a trunk between the 2 x PBX's?<div><br></div><div>There are H323 and SIP tunnelling features that should pass the Q.SIG between them transparently.</div>
<div><br></div><div>See this for example..</div><div><a href="http://www.cisco.com/en/US/docs/ios/voice/sip/configuration/guide/tunneling_qsig_ps6441_TSD_Products_Configuration_Guide_Chapter.html" target="_blank">http://www.cisco.com/en/US/docs/ios/voice/sip/configuration/guide/tunneling_qsig_ps6441_TSD_Products_Configuration_Guide_Chapter.html</a></div>
<div><br></div><div>Cheers,</div><div><br></div><div>Tim.</div><div><br><div class="gmail_quote"><div><div></div><div>On Mon, Nov 2, 2009 at 4:42 PM, Syed Khalid Ali <span dir="ltr"><<a href="mailto:syed.khalid.khursheed@gmail.com" target="_blank">syed.khalid.khursheed@gmail.com</a>></span> wrote:<br>
</div></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div><div></div><div>There is NO CallManager involved. Just two voice gateways.<br><br><div class="gmail_quote">
On Sun, Nov 1, 2009 at 11:31 PM, Nate VanMaren <span dir="ltr"><<a href="mailto:VanMarenNP@ldschurch.org" target="_blank">VanMarenNP@ldschurch.org</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
<div>
<div dir="ltr"><font face="Tahoma" color="#000000" size="2">Is there a Cisco Communications Manager controling the voicegateways? H.323 support for QSIG is very very limited, you need to run the gateways with MGCP, and you'll get much better results with QSIG.</font></div>
<div dir="ltr"><font face="tahoma" size="2"></font> </div>
<div dir="ltr"><font face="tahoma" size="2">-Nate</font></div>
<div style="direction:ltr">
<hr>
<font face="Tahoma" size="2"><b>From:</b> <a href="mailto:cisco-voip-bounces@puck.nether.net" target="_blank">cisco-voip-bounces@puck.nether.net</a> [<a href="mailto:cisco-voip-bounces@puck.nether.net" target="_blank">cisco-voip-bounces@puck.nether.net</a>] On Behalf Of Syed Khalid Ali [<a href="mailto:syed.khalid.khursheed@gmail.com" target="_blank">syed.khalid.khursheed@gmail.com</a>]<br>
<b>Sent:</b> Sunday, November 01, 2009 1:39 AM<br>
<b>To:</b> <a href="mailto:cisco-voip@puck.nether.net" target="_blank">cisco-voip@puck.nether.net</a><br>
<b>Subject:</b> [cisco-voip] Calling Name Issue with Nortel 11c and 61c with QSIG<br>
</font><br>
</div><div><div></div><div>
<div></div>
<div>Greeting:
<div><br>
</div>
<div>I have the following scenario. Two PBXes 11c and 61c. Both connected with Cisco Voice gateways as following:</div>
<div>11c----------------E1----------------VG1----------------VG2----------------61c</div>
<div>Calls are working fine but I could not able to get the Caller Name at each site. Both PBXes are acting the ISDN network side but QSIG.</div>
<div><br>
</div>
<div>11c has extension of 12XX and </div>
<div>61c has 2XXX, 3XXX, 4XXX</div>
<div><br>
</div>
<div>After looking at the command reference, I concluded that following commands should work: </div>
<div>isdn supp-service name calling</div>
<div>isdn outgoing display-ie</div>
<div><br>
</div>
<div>I did the following config on both sides:</div>
<div>
<div>interface Serial0/3/0:15</div>
<div> no ip address</div>
<div> no logging event link-status</div>
<div> isdn switch-type primary-qsig</div>
<div> isdn incoming-voice voice</div>
<div> isdn supp-service name calling</div>
<div> isdn send-alerting</div>
<div> isdn sending-complete</div>
<div> isdn outgoing display-ie</div>
<div> no cdp enable</div>
<div><br>
</div>
</div>
<div>but I am getting the following error message in Q931 debugs:</div>
<div>
<div>ISDN Se0/3/0:15 Q931: Applying typeplan for sw-type 0x16 is 0x0 0x1, Calling num</div>
<div> 1216</div>
<div>ISDN Se0/3/0:15 Q931: Applying typeplan for sw-type 0x16 is 0x0 0x9, Called num</div>
<div>0302</div>
<div>ISDN Se0/3/0:15 Q931: TX -> SETUP pd = 8 callref = 0x071A</div>
<div> Sending Complete</div>
<div> Bearer Capability i = 0x8090A3</div>
<div> Standard = CCITT</div>
<div> Transfer Capability = Speech</div>
<div> Transfer Mode = Circuit</div>
<div> Transfer Rate = 64 kbit/s</div>
<div> Channel ID i = 0xA9839F</div>
<div> Exclusive, Channel 31</div>
<div> Progress Ind i = 0x8183 - Origination address is non-ISDN</div>
<div> Calling Party Number i = 0x0180, '1216'</div>
<div> Plan:ISDN, Type:Unknown</div>
<div> Called Party Number i = 0x89, '0302'</div>
<div> Plan:Private, Type:Unknown</div>
<div> Locking Shift to Codeset 5</div>
<div> Codeset 5 IE 0x31 i = 0x80</div>
<div> Codeset 5 IE 0x32 i = 0x81</div>
<div>ISDN Se0/3/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0x871A</div>
<div> Channel ID i = 0xA9839F</div>
<div> Exclusive, Channel 31</div>
<div>ISDN Se0/3/0:15 Q931: RX <- ALERTING pd = 8 callref = 0x871A</div>
<div> Locking Shift to Codeset 5</div>
<div> Codeset 5 IE 0x32 i = 0x81</div>
<div><br>
</div>
<div> ISDN Se0/3/0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0x071A</div>
<div> Cause i = 0x8090 - Normal call clearing</div>
<div>ISDN Se0/3/0:15 Q931: RX <- CONNECT pd = 8 callref = 0x871A</div>
<div> Progress Ind i = 0x8182 - Destination address is non-ISDN</div>
<div> Connected Number i = 0x0080, '4446'</div>
<div> Locking Shift to Codeset 5</div>
<div> Codeset 5 IE 0x32 i = 0x81</div>
</div>
<div>
<div>ISDN Se0/3/0:15 **ERROR**: Ux_BadMsg: Invalid Message for call state 11, call id</div>
<div> 0x8E1D, call ref 0x71A, event 0x7</div>
<div>ISDN Se0/3/0:15 Q931: TX -> STATUS pd = 8 callref = 0x071A</div>
<div> Cause i = 0x80E507 - Message not compatible with call state</div>
<div> Call State i = 0x0B</div>
<div>
<div>ISDN Se0/3/0:15 Q931: RX <- RELEASE pd = 8 callref = 0x871A</div>
<div>ISDN Se0/3/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x071A</div>
</div>
</div>
<div><br>
</div>
<div>-- </div>
<div>Thanks,<br>
Syed Khalid Ali<br>
<br>
</div>
</div>
</div></div><div>
<p class="MsoNormal"><span><font color="#666666"><br><br> NOTICE: This email message is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message.</font></span></p>
<br>
</div></div>
</blockquote></div><br><br clear="all"><br>-- <br>Thanks,<br><font color="#888888">Syed Khalid Ali<br><br>
</font><br></div></div>_______________________________________________<br>
cisco-voip mailing list<div><br>
<a href="mailto:cisco-voip@puck.nether.net" target="_blank">cisco-voip@puck.nether.net</a><br>
</div><a href="https://puck.nether.net/mailman/listinfo/cisco-voip" target="_blank">https://puck.nether.net/mailman/listinfo/cisco-voip</a><br>
<br></blockquote></div><font color="#888888"><br><br clear="all"><br>-- <br><br>Cheers,<br><br>Tim<br><br><br>Sent from Sydney, Nsw, Australia
</font></div>
</blockquote></div><br><br clear="all"><br>-- <br><br>Cheers,<br><br>Tim<br><br><br>Sent from Sydney, Nsw, Australia
</div></div>
</div></div></blockquote></div><br><br>
</div></div></div>