So basically use a translation pattern on the incoming voip dial-peer to change the number, then create unique destination-patterns in pots dial-peers and strip the digits? <br><br>Thanks,<br>Brian<br><br><br><div class="gmail_quote">
On Tue, Jun 8, 2010 at 6:58 PM, Mac GroupStudy <span dir="ltr"><<a href="mailto:mac.groupstudy@gmail.com">mac.groupstudy@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">
You could come up with some digit manipulation rules based on the calling party. However, you will be modifying the called party. You may prefix a specific digit(s) to the called number based on the calling party and then strip it off or allow it to be "consumed" if you use specific digits at the POTS dial-peer. Does that make sense?<div>
<br></div><div><br><br><div class="gmail_quote"><div><div></div><div class="h5">On Tue, Jun 8, 2010 at 4:20 PM, Brian Schultz <span dir="ltr"><<a href="mailto:bms314@gmail.com" target="_blank">bms314@gmail.com</a>></span> wrote:<br>
</div></div><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;"><div><div></div><div class="h5">
<div>I'm sure there is a simple command to accomplish this, but I'm not figuring it out. </div>
<div> </div>
<div>I have a 2801 gateway at a remote site with 2 analog FXS phones. This is connected by a PTP T1 to another 2801 at HQ with 2 FXO lines to a PBX. I'm not using any CallManager, just H323 gateways. All calling between the sites is good based off of dial-peers. </div>
<div> </div>
<div>The only thing I can't get to work is how to route a call out to a FXO based on the calling number. For instance, if a single FXS phone from the remote gateway trys to dial a 4 digit extension on the PBX, what command do I configure in the dial-peer to force that call to use FXO port 0/0/0? I would want the other FXS phone at the remote gateway to always use the other FXO port 0/0/1 for outbound calls. Is there a dial-peer command to filter or "policy-route" based on the calling-number?</div>
<div> </div>
<div>Thanks,</div>
<div>Brian</div><font color="#888888">
<div> </div>
<div> </div>
<div> </div>
<div> </div>
</font><br></div></div>_______________________________________________<br>
cisco-voip mailing list<br>
<a href="mailto:cisco-voip@puck.nether.net" target="_blank">cisco-voip@puck.nether.net</a><br>
<a href="https://puck.nether.net/mailman/listinfo/cisco-voip" target="_blank">https://puck.nether.net/mailman/listinfo/cisco-voip</a><br>
<br></blockquote></div><br></div>
</blockquote></div><br>