<div>Hi,</div>
<div> </div>
<div>can you check the region on ccm and the codecs??</div>
<div> </div>
<div>Thanks</div>
<div><br><br> </div>
<div class="gmail_quote">2010/8/9 Guilherme Loch Waltrick Góes <span dir="ltr"><<a href="mailto:glwgoes@gmail.com">glwgoes@gmail.com</a>></span><br>
<blockquote style="BORDER-LEFT: #ccc 1px solid; MARGIN: 0px 0px 0px 0.8ex; PADDING-LEFT: 1ex" class="gmail_quote">Hi guys,<br><br>We just upgraded a site that was running a 2801 with a ISDN PRI link<br>to a PBX to a 2911 with the exact same setup. The setup with the 2801<br>
was running just fine. The problem is, running with the same config on<br>the 2911 we keep getting MANY Line Code Violations and other assorted<br>errors, the calls are very noisy and sometimes we can't place the<br>calls from this site to the other sites.<br>
<br>Did anyone experienced the same situation? How can a solve this problem?<br><br>Bellow is some info about this router:<br><br>#sh controllers e1 0/1/0<br>E1 0/1/0 is up.<br> Applique type is Channelized E1 - balanced<br>
Description: Enlace E1 com o PABX<br> No alarms detected.<br> alarm-trigger is not set<br> Version info Firmware: 20090408, FPGA: 13, spm_count = 0<br> Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.<br>
Data in current interval (38 seconds elapsed):<br> 20724 Line Code Violations, 170 Path Code Violations<br> 1 Slip Secs, 0 Fr Loss Secs, 38 Line Err Secs, 0 Degraded Mins<br> 38 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs<br>
Data in Interval 1:<br> 415943 Line Code Violations, 4586 Path Code Violations<br> 6 Slip Secs, 0 Fr Loss Secs, 900 Line Err Secs, 15 Degraded Mins<br> 900 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs<br>
Total Data (last 1 15 minute intervals):<br> 415943 Line Code Violations, 4586 Path Code Violations,<br> 6 Slip Secs, 0 Fr Loss Secs, 900 Line Err Secs, 15 Degraded Mins,<br> 900 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs<br>
<br>#sh ver<br>Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version<br>15.0(1)M1, RELEASE SOFTWARE (fc1)<br><br>#sh run<br>-- some output ommited --<br>network-clock-participate wic 1<br><br>isdn switch-type primary-qsig<br>
isdn gateway-max-interworking<br><br>voice-card 0<br> dsp services dspfarm<br>!<br>!<br>!<br>voice class codec 1<br> codec preference 1 g729br8<br> codec preference 2 g729r8<br>!<br>!<br>controller E1 0/1/0<br> framing NO-CRC4<br>
clock source internal<br> pri-group timeslots 1-12,16<br> description Enlace E1 com o PABX<br>!<br>interface GigabitEthernet0/0<br> description LAN<br> bandwidth 1000000<br> ip address 172.26.130.2 255.255.255.192<br> ip wccp 61 redirect in<br>
ip flow ingress<br> ip flow egress<br> duplex auto<br> speed auto<br> h323-gateway voip interface<br> h323-gateway voip id GK_SEDE_1 ipaddr 172.254.1.3 1719<br> h323-gateway voip id GK_SEDE_2 ipaddr 172.254.1.2 1719<br> h323-gateway voip h323-id GW_XXXX<br>
h323-gateway voip tech-prefix 1#<br> h323-gateway voip bind srcaddr 172.26.130.2<br> service-policy input MARKQoSOUT<br><br>!<br>interface Serial0/1/0:15<br> no ip address<br> encapsulation hdlc<br> isdn switch-type primary-qsig<br>
isdn overlap-receiving<br> isdn incoming-voice voice<br> isdn contiguous-bchan<br> no cdp enable<br>!<br>voice-port 0/1/0:15<br> cptone BR<br>!<br>dial-peer voice 5 pots<br> description Internal Extensions to the PBX<br>
destination-pattern 3396....<br> direct-inward-dial<br> port 0/1/0:15<br> forward-digits 4<br> no register e164<br>!<br>dial-peer voice 13 voip<br> description Output dial-peer<br> destination-pattern 3.......<br> session target ras<br>
voice-class codec 1<br>!<br>!<br>gateway<br>!<br>!<br>!<br>gatekeeper<br> shutdown<br><br>Guilherme Loch Góes<br><br>_______________________________________________<br>cisco-voip mailing list<br><a href="mailto:cisco-voip@puck.nether.net">cisco-voip@puck.nether.net</a><br>
<a href="https://puck.nether.net/mailman/listinfo/cisco-voip" target="_blank">https://puck.nether.net/mailman/listinfo/cisco-voip</a><br></blockquote></div><br>