<html><head>
<meta http-equiv="Content-Type" content="text/html; charset=us-ascii">
</head>
<body style="word-wrap: break-word; -webkit-nbsp-mode: space; -webkit-line-break: after-white-space; ">
<span style="font-family:Calibri, Arial, Helvetica, sans-serif;font-size:11pt;color:black">I would expect tcp 1500 byte packets alone to cut file transfer time in half vs udp 512 byte in tftp , does peer firmware sharing still use tftp or the new http when
this feature goes live?<br>
<br>
Sent from my Android phone using TouchDown (www.nitrodesk.com)<br>
<br>
<span style="color:black">-----Original Message----- <br>
<b>From:</b> Wes Sisk [wsisk@cisco.com]<br>
<b>Received:</b> Monday, 14 May 2012, 10:33am<br>
<b>To:</b> Aaron Riemer [ariemer@amnet.net.au]; Jason Aarons (AM) [jason.aarons@us.didata.com]; Ryan Ratliff (rratliff) [rratliff@cisco.com]<br>
<b>CC:</b> Cisco VOIP [cisco-voip@puck.nether.net]<br>
<b>Subject:</b> Re: [cisco-voip] 7965G delays registering on SCCP v9 firmware<br>
<br>
</span></span>
<div>3rd gen phones (see: <a href="https://supportforums.cisco.com/docs/DOC-8131#Definitions">
https://supportforums.cisco.com/docs/DOC-8131#Definitions</a>)
<div><br>
</div>
<div>*should* get http download in 9.3(1) so long as things go as planned with:</div>
<div>CSCsy15970</div>
<div><br>
</div>
<div>this is future planning and therefore subject to change.</div>
<div><br>
</div>
<div>Regards,</div>
<div>Wes</div>
<div><br>
</div>
<div><br>
<div>
<div>On May 14, 2012, at 9:41 AM, Wes Sisk wrote:</div>
<br class="Apple-interchange-newline">
<base href="x-msg://78/">
<div style="word-wrap: break-word; -webkit-nbsp-mode: space; -webkit-line-break: after-white-space; ">
10-20 minutes sounds like the time to download the larger loads required by the 79x2 and 79x5 loads. When you reset the phones they re-attempt TFTP. The phones will spin on TFTP transfer for 10-20 minutes, then give up most likely on a failure, and register
using the old phone load.
<div><br>
</div>
<div>If you check one of the phones that experiences this issue - either in RTMT or in the phone webpage, has it successfully upgraded to the 9.x release or is it still running the 8.x release such that they would attempt upgrade on next reset.</div>
<div><br>
</div>
<div>I was not under the impression that 79x2 and 79x5 model phones had http transfer of phone loads yet. That would be a good point of clarification as to how the phones are attempting upgrade and if any problems occur in that attempt. Usually detailed TFTP
traces are adequate.</div>
<div><br>
</div>
<div><a href="https://supportforums.cisco.com/docs/DOC-16943">https://supportforums.cisco.com/docs/DOC-16943</a></div>
<div><br>
</div>
<div>Regards,</div>
<div>Wes<br>
<div><br>
<div>
<div>On May 13, 2012, at 2:00 AM, Aaron Riemer wrote:</div>
<br class="Apple-interchange-newline">
<div lang="EN-AU" link="blue" vlink="purple">
<div class="WordSection1" style="page: WordSection1; ">
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
Hey guys,<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
We are gradually upgrading our fleet of 7965G's to SCCP v9 software from v8.<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
We have found an issue at remote sites (higher latency) where phones (with any 9.x firmware) are taking upward of 10-20 minutes to register! This delay seems to only occur when a full power off / power on occurs.<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
Downgrade the phones back to v8.x and whola! No problem.<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
We are going to try and simulate this in the lab with a WAN sim and then probably get TAC involved. I suspect it has something to do with the extra latency involved but as mentioned we have had no trouble with v8.x software.<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
Has anyone come across this problem? It seems a bit oddball I know.<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
Any hints or suggestions are most welcome.<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
Thanks,<o:p></o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
<o:p> </o:p></div>
<div style="margin-top: 0cm; margin-right: 0cm; margin-left: 0cm; margin-bottom: 0.0001pt; font-size: 11pt; font-family: Calibri, sans-serif; ">
Aaron.<o:p></o:p></div>
</div>
_______________________________________________<br>
cisco-voip mailing list<br>
<a href="mailto:cisco-voip@puck.nether.net" style="color: blue; text-decoration: underline; ">cisco-voip@puck.nether.net</a><br>
<a href="https://puck.nether.net/mailman/listinfo/cisco-voip" style="color: blue; text-decoration: underline; ">https://puck.nether.net/mailman/listinfo/cisco-voip</a><br>
</div>
</div>
<br>
</div>
</div>
</div>
_______________________________________________<br>
cisco-voip mailing list<br>
<a href="mailto:cisco-voip@puck.nether.net">cisco-voip@puck.nether.net</a><br>
https://puck.nether.net/mailman/listinfo/cisco-voip<br>
</div>
<br>
</div>
</div>
</body>
</html>