<div>New findings:</div><div> </div><div>On the gateway that was able to display FXS port information in a subscriber, I changed the config to register it to a Sub and left out the Pub. The gateway successfully registered to Sub. </div>
<div> </div><div>This gateway is running the same ios as one that does not register to sub. Everything else appears the same but I will comb through the config to find any discrepancy. Will post results if I find any! Input still greatly appreciated. :)</div>
<div> </div><div>-Diana<br><br></div><div class="gmail_quote">On Thu, Jun 14, 2012 at 11:51 AM, Auralythic <span dir="ltr"><<a href="mailto:auralythic@gmail.com" target="_blank">auralythic@gmail.com</a>></span> wrote:<br>
<blockquote style="margin:0px 0px 0px 0.8ex;padding-left:1ex;border-left-color:rgb(204,204,204);border-left-width:1px;border-left-style:solid" class="gmail_quote"><div>Scratch that, found something that blew that theory out of the water. Back to the drawing board...</div>
<div> </div><div>Still doesn't explain why the FXS config pages are not loading for some gateways on the Subs.</div>
<div> </div><div>-Diana<br><br></div><div class="HOEnZb"><div class="h5"><div class="gmail_quote">On Thu, Jun 14, 2012 at 11:48 AM, Auralythic <span dir="ltr"><<a href="mailto:auralythic@gmail.com" target="_blank">auralythic@gmail.com</a>></span> wrote:<br>
<blockquote style="margin:0px 0px 0px 0.8ex;padding-left:1ex;border-left-color:rgb(204,204,204);border-left-width:1px;border-left-style:solid" class="gmail_quote"><div>So this is interesting: </div><div> </div><div>If I log into a Subscriber's admin webpage and choose a gateway with an ios rev of 15.1 or greater and click on a configured FXS port, the subsequent page loads blank aside from the CM Admin header. If I go into a gateway with ios 15.0 or lower or a flavor of 12 and do the same, the FXS port configuration page loads completely.</div>
<div> </div><div>Is there an issue with the ios revision and the communication between gateway and subscribers?<br></div><div>-Diana<br></div><div><div><div class="gmail_quote">On Thu, Jun 14, 2012 at 11:41 AM, Auralythic <span dir="ltr"><<a href="mailto:auralythic@gmail.com" target="_blank">auralythic@gmail.com</a>></span> wrote:<br>
<blockquote style="margin:0px 0px 0px 0.8ex;padding-left:1ex;border-left-color:rgb(204,204,204);border-left-width:1px;border-left-style:solid" class="gmail_quote"><div>Yes, "Backup Ready" is good. <br></div><div>
<div>"You can change up your commands to force them / test the other subs. "</div><div> </div></div><div>That's the problem. It will fail for all subs. Only one server will register, I get that, but it is either Publisher or nothing. The debug is showing there is a hangup somewhere but I don't yet know enough to understand where. I'm googling the bits and pieces to try and find something.</div>
<div> </div><div>Thanks!</div><div> </div><div>-Diana</div><div><div><div><br> </div><div class="gmail_quote">On Thu, Jun 14, 2012 at 11:36 AM, Lelio Fulgenzi <span dir="ltr"><<a href="mailto:lelio@uoguelph.ca" target="_blank">lelio@uoguelph.ca</a>></span> wrote:<br>
<blockquote style="margin:0px 0px 0px 0.8ex;padding-left:1ex;border-left-color:rgb(204,204,204);border-left-width:1px;border-left-style:solid" class="gmail_quote"><div bgcolor="#FFFFFF"><div>I believe showing backup ready is normal. Devices only register to one server at a time. </div>
<div><br></div><div>You can change up your commands to force them / test the other subs. </div><div><br></div><div>I'm not at a PC to access my routers, but I'm pretty sure the behaviour is the same. <br><br>Sent from my iPhone...<div>
<br></div><div>"There's no place like 127.0.0.1"</div></div><div><div><div><br>On Jun 14, 2012, at 7:28 AM, Auralythic <<a href="mailto:auralythic@gmail.com" target="_blank">auralythic@gmail.com</a>> wrote:<br>
<br></div><div></div><blockquote type="cite"><div><div>Good day, all,</div><div> </div><div>We have a ucm8 cluster with a publisher and three subscribers. All of our gateways configured in 8.6.1 (3825s, 3925s) all register normally to the publisher but none will register to the subscribers. Hostnames are all correct. What should I be looking for? Here is a snippet of the mgcp config:</div>
<div> </div><div>ccm-manager redundant-host <a href="http://b.subscriber.com" target="_blank">b.subscriber.com</a> <a href="http://c.subscriber.com" target="_blank">c.subscriber.com</a><br>ccm-manager mgcp<br>no ccm-manager fax protocol cisco<br>
ccm-manager music-on-hold<br>
ccm-manager config server {IP address of Publisher} <br>ccm-manager config<br>!<br>mgcp<br>mgcp call-agent <a href="http://a.publisher.com" target="_blank">a.publisher.com</a> 2427 service-type mgcp version 0.1<br>mgcp dtmf-relay voip codec all mode nte-gw<br>
mgcp rtp unreachable timeout 1000 action notify<br>mgcp package-capability rtp-package<br>mgcp package-capability sst-package<br>mgcp package-capability pre-package<br>no mgcp package-capability res-package<br>no mgcp package-capability fxr-package<br>
no mgcp timer receive-rtcp<br>mgcp timer nse-response t38 250<br>mgcp sdp simple<br>mgcp fax rate 9600<br>mgcp fax t38 inhibit<br>mgcp bind control source-interface GigabitEthernet0/0<br>mgcp bind media source-interface GigabitEthernet0/0<br>
!<br>mgcp profile default</div><div> </div><div>---------------------------------------</div><div>And a sh ccm-man</div><div> </div><div>Priority Status Host<br>============================================================<br>
Primary Registered <a href="http://a.publisher.com" target="_blank">a.publisher.com</a> {IP Address}</div><div>First Backup Backup Ready <a href="http://b.subscriber.com" target="_blank">b.subscriber.com</a> {IP Address}</div>
<div>Second Backup Backup Ready <a href="http://c.subscriber.com" target="_blank">c.subscriber.com</a> {IP Address}</div><div>Current active Call Manager: {<a href="http://a.publisher.com" target="_blank">a.publisher.com</a> IP Address}</div>
<div>Backhaul/Redundant link port: 2428<br>
Failover Interval: 30 seconds<br>Keepalive Interval: 15 seconds<br>Last keepalive sent: 10:18:43 edt Jun 14 2012 (elapsed time: 00:00:09)<br>Last MGCP traffic time: 10:18:43 edt Jun 14 2012 (elapsed time: 00:00:09)<br>
Last failover time: 09:35:20 edt Jun 14 2012 from (<a href="http://a.publisher.com" target="_blank">a.publisher.com</a> IP Address)<br>Last switchback time: 09:34:44 edt Jun 14 2012 from (<a href="http://a.subscriber.com" target="_blank">a.subscriber.com</a> IP Address)<br>
Switchback mode: Graceful<br>MGCP Fallback mode: Not Selected<br>
Last MGCP Fallback start time: None<br>Last MGCP Fallback end time: None<br>MGCP Download Tones: Disabled <br>TFTP retry count to shut Ports: 2 </div><div>Configuration Auto-Download Information<br>=======================================<br>
Current version-id: 1339679546-89708b39-0266-4c1c-9512-ea5d5ff2af23<br>Last config-downloaded:00:00:00<br>Current state: Waiting for commands<br>Configuration Download statistics:<br> Download Attempted : 2<br>
Download Successful : 2<br> Download Failed : 0<br> TFTP Download Failed : 0<br> Configuration Attempted : 1<br> Configuration Successful : 1<br>
Configuration Failed(Parsing): 0<br> Configuration Failed(config) : 0<br>Last config download command: New Registration<br>FAX mode: disable<br>Configuration Error History:</div><div> </div><div>-------------------------------------</div>
<div>Any help and points to the right direction are appreciated. Obviously, we want them to register to the subs and fail to another sub or the pub.</div><div> </div><div>Thank you,</div><div> </div><div>-Diana</div>
</div></blockquote></div></div><blockquote type="cite"><div><span>_______________________________________________</span><div><br><span>cisco-voip mailing list</span><br><span><a href="mailto:cisco-voip@puck.nether.net" target="_blank">cisco-voip@puck.nether.net</a></span><br>
<span><a href="https://puck.nether.net/mailman/listinfo/cisco-voip" target="_blank">https://puck.nether.net/mailman/listinfo/cisco-voip</a></span><br></div></div></blockquote></div></blockquote></div><br>
</div></div></blockquote></div><br>
</div></div></blockquote></div><br>
</div></div></blockquote></div><br>