FW: [f-nsp] editing accesslists w/o causing interrupts

[Scott Weeks]

On Fri, 5 Mar 2004, Gerlof Dijk wrote:

:  For Cisco we use the folling methode:
:
:  Cut & past your acl into a notepad.
:  Rename the acl number
:  Make your changes
:  Cut & past the new acl into your device
:  Active the new acl on the interface
:  Remove the old acl form the interface
:
:  On foundry: hopefully the same:-)


Yes, it's the same for Foundry...

scott





:
:  Regards
:
:  Gerlof
:
:  -----Original Message-----
:  From: foundry-nsp-bounces at puck.nether.net
:  [mailto:foundry-nsp-bounces at puck.nether.net] On Behalf Of Michael Renner
:  Sent: vrijdag 5 maart 2004 20:14
:  To: foundry-nsp at puck.nether.net
:  Subject: [f-nsp] editing accesslists w/o causing interrupts
:
:
:  Hi!
:
:  Is it possible to edit accesslists without having to move the
:  "permit/deny any" entries "down" in the access-list manually (e.g. if
:  you've added new entries)? If you move the permit/deny any entries by
:  hand you could cause short disruptions in service (between the e.g. "no
:  access 20 permit any" "access 20 permit any" commands). A workaround
:  would be to temporarily remove the access-list from the given service,
:  but when you use it in multiple spots in the config, this can be quite
:  cumbersome.
:
:  Any ideas?
:
:  --
:
:  best regards,
:    Michael Renner
:
:  Preisvergleich Internet Services AG
:  Franzensbrückenstraße 8/2/16, A-1020 Wien
:  Tel: +43 1 5811609 56
:  Fax: +43 1 5811609 55 _______________________________________________
:  foundry-nsp mailing list
:  foundry-nsp at puck.nether.net
:  http://puck.nether.net/mailman/listinfo/foundry-nsp
:
:
:  _______________________________________________
:  foundry-nsp mailing list
:  foundry-nsp at puck.nether.net
:  http://puck.nether.net/mailman/listinfo/foundry-nsp
: