[f-nsp] Foundry trunks <=> Cisco Etherchannel

[Gregory Edigarov]

I have a strange problem trying to trunk the 4506 and ServerIron.

ServerIron#sh ver
SW: Version 09.1.00cT22 Copyright (c) 1996-2003 Foundry Networks, Inc.
    Compiled on Feb 13 2005 at 09:00:10 labeled as WSM09100c
    (3603704 bytes) from Primary WSM09100c.bin
HW: ServerIron 400 Switch, SYSIF version 21, Serial #: Non-exist
==========================================================================
SL 1: B0GMR WSM Management Module, SYSIF 2, ACTIVE
    Serial #: Non-exist
  0 MB SHM, 3 Application Processors
8192 KB BRAM, SMC version 1, BM version 21
SW: (1)09.1.00cT72 (2)09.1.00cT72 (3)09.1.00cT72
==========================================================================
SL 2: B8GC Copper Switch Module, SYSIF 2
    Serial #: Non-exist
2048 KB BRAM, SMC version 1, BM version 21
512 KB PRAM(512K+0K) and 2048*8 CAM entries for DMA  4, version 0209
512 KB PRAM(512K+0K) and shared CAM entries for DMA  5, version 0209
512 KB PRAM(512K+0K) and 2048*8 CAM entries for DMA  6, version 0209
512 KB PRAM(512K+0K) and shared CAM entries for DMA  7, version 0209
==========================================================================
Active management module:
466 MHz Power PC processor 750 (version 8/8302) 66 MHz bus
512 KB boot flash memory
16384 KB code flash memory
256 KB SRAM
512 MB DRAM
The system uptime is 1 days 7 hours 59 minutes 15 seconds
The system started at 01:00:39 Eastern Tue Aug 30 2005

The system : started=warm start   reloaded=by "reload"

4506:
Cisco Internetwork Operating System Software
IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 
12.2(18)EW, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Fri 30-Jan-04 02:04 by hqluong
Image text-base: 0x00000000, data-base: 0x010B0624

ROM: 12.1(12r)EW
Dagobah Revision 55, Swamp Revision 16

cs4506 uptime is 7 weeks, 15 hours, 46 minutes
System returned to ROM by reload
System restarted at 17:28:01 EDT Tue Jul 12 2005
System image file is "bootflash:cat4000-i9s-mz.122-18.EW.bin"

cisco WS-C4506 (MPC8245) processor (revision 7) with 262144K bytes of 
memory.
Processor board ID FOX0748024H
Last reset from Reload
9 Virtual Ethernet/IEEE 802.3  interface(s)
50 Gigabit Ethernet/IEEE 802.3 interface(s)
467K bytes of non-volatile configuration memory.

Configuration register is 0x2102

on ServerIron's side I have:

trunk switch ethe 2/1 to 2/2
port-name "Goes to 2/10 of core" ethernet 2/1
trunk switch ethe 2/7 to 2/8
port-name "Goes to 4506" ethernet 2/7

and on Cisco side I have:

interface range GigabitEthernet2/3 - 4
switchport access vlan 55
switchport mode access
channel-group  1 mode passive -- tryed all possible modes actually.....
logging event link-status
load-interval 30
speed 1000
no qos

it doesn't work.
I have also tryed to configure port-channel interface.

interface Port-channel1
switchport
switchport access vlan 55
switchport mode access
load-interval 30

does not work either.

What am I doing wrong?

Thanks a lot in advance. :-)

-- 
With best regards,
	GRED-RIPE