[f-nsp] dm raw command output

[Brent Van Dussen]

You will also probably want to set a maximum with dm raw max <# of packets> 
typically a 100 or so at a time is nice on everything.

Then just type dm raw all by itself to start dumping packets to your 
terminal.  type dm raw again to turn it off if you don't have a maximum set 
or you want to break out of it sooner.

This is only for packets going to the CPU, you won't see any packets that 
are being switched by the hardware.

-Brent

At 10:08 AM 1/19/2006, Gregory Edigarov wrote:
>Hello,
>
>what is the full command sequence  for dm raw  subcommands?
>I wanna  look at the traffic as it  flows through my router. I was told
>that is done with "dm raw mode brief" command, but I cannot get an output.
>Should I look at the console, or there is an option redirecting output
>to where I want?
>
>Thank you.
>
>
>--
>With best regards,
>         GRED-RIPE
>
>_______________________________________________
>foundry-nsp mailing list
>foundry-nsp at puck.nether.net
>http://puck.nether.net/mailman/listinfo/foundry-nsp