[f-nsp] BGP between XMRs (or from XMR to Juniper)

Dan Spataro dspataro at corp.nac.net
Thu Apr 3 16:06:23 EDT 2008


David,

Try and add this to your XMR config

router bgp
 local-as 64555
 neighbor 172.16.0.5 remote-as 64555
 neighbor 172.16.0.5 next-hop-self
 neighbor 172.16.0.5 update-source loopback 1 ---> add this

Thanks,
Dan

-----Original Message-----
From: foundry-nsp-bounces at puck.nether.net
[mailto:foundry-nsp-bounces at puck.nether.net] On Behalf Of David Ball
Sent: Thursday, April 03, 2008 3:43 PM
To: foundry-nsp at puck.nether.net
Subject: Re: [f-nsp] BGP between XMRs (or from XMR to Juniper)


  I suppose the BGP config might be helpful:

router bgp
 local-as 64555
 neighbor 172.16.0.5 remote-as 64555
 neighbor 172.16.0.5 next-hop-self

 address-family ipv4 unicast
 exit-address-family

 address-family ipv4 multicast
 exit-address-family

 address-family ipv6 unicast
 exit-address-family

 address-family vpnv4 unicast
 exit-address-family
end of BGP configuration



On 03/04/2008, David Ball <davidtball at gmail.com> wrote:
>  I'm brand new to Foundry devices and thought I was doing well, but
> somehow I'm stumbling at getting something as simple as BGP running
> (iBGP), and I can't afford to tear much more hair out.
>  Is much else needed just to establish a session besides:
>
> -ip connectivity (PtP and loopback IPs seen on both sides, all
pingable)
> -an IGP (or static routes) to advertise loopback IPs (using OSPF)
> -local-as
> -neighbor statement specifying a neighbor IP and remote-as
>
>  I know there are dozens of other settings I can (and will) employ,
> but just to get a session up, should it require much more ?
>  When trying to establish a session to a Juniper m10 with full
> traceoptions enabled, the m10 indicated:
>
> Apr  3 10:30:20.868934 bgp_recv: peer 172.16.0.4 (Internal AS 64555):
> received unexpected EOF
>
>  where 172.16.0.4 is the XMR.  I (apparently) have full logging
> enabled on the XMR, but it's telling me nothing (unless I'm not asking
> it properly).  The following shows logging enabled, but I see nothing
> about BGP:
>
> Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
>    Buffer logging: level ACDMEINW, 32 messages logged
>    level code: A=alert C=critical D=debugging M=emergency E=error
>                I=informational N=notification W=warning
>
>
> Any thoughts or nudges in the right direction would be appreciated.
> Of all the things I plan to configure on the XMRs, I figured BGP would
> be the easiest, but clearly I'm missing something.  Thanks in advance.
>
> David
>
_______________________________________________
foundry-nsp mailing list
foundry-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/foundry-nsp



More information about the foundry-nsp mailing list