[f-nsp] Transparent VLL through XMR and J-6350

[Brad Fleming]

Hello all,

I'm new to the list but haven't found an answer to my question in the  
archives. If the topic has already been covered, my apologies.

I'm attempting to build an MPLS VLL using the following gear:
1) Foundry / Brocade NetIron XMR running IronWare 4.0.00a
2) Juniper J-6350 running JunOS 9.4R1.8 (Enhanced Services)

I'm having problems getting the VLL to pass both tagged and untagged  
traffic. For now, I'd be happy just getting untagged traffic across  
the link and tackle the multiple VLAN tags later. Little victories, if  
you will! :D Both devices claim the service is up but traffic does not  
dump out the other side.

I'm 99.9% sure I'm missing something basic but I don't have a good  
configuration example for this setup.

Any help or insight would be GREATLY appreciated! Thanks in advance!

-brad fleming
--
Brad Fleming
Network Engineer
Kansas Research and Education Network
Office:    785-856-9800 x.222
Moblie:  785-865-7231
NOC:     866-984-3662




Here's a couple show commands:

telnet at fake-ksu(config-mpls-vll-test)#show mpls vll
Name      VC-ID      Vll-peer        End-point                  State  
Tunnel-LSP
test      2          164.113.199.108 untag e 1/20               UP     
tnl0
telnet at fake-ksu(config-mpls-vll-test)#

brad# run show l2circuit connections extensive
Layer-2 Circuit Connections:
<<<deleted legend for brevity>>>
Neighbor: 164.113.199.103
     Interface                 Type  St     Time last up          # Up  
trans
     ge-0/0/1.0(vc 2)          rmt   Up     Apr 15 05:11:58  
2009           1
       Remote PE: 164.113.199.103, Negotiated control-word: No
       Incoming label: 299776, Outgoing label: 800000
       Local interface: ge-0/0/1.0, Status: Up, Encapsulation: ETHERNET
     Connection History:
	<<<deleted history for brevity>>>



Here's the pertinent config from both devices:
------XMR:
!
router mpls
!
   mpls-interface e1/1
   ldp-enable
!
  vll test 2 raw-mode
   vll-mtu 9178
   vll-peer 164.113.199.108
   untag e 1/20
!
end of MPLS configuration

-------J-6350:
interfaces {
     ge-0/0/0 {
         description "link to NetIron";
         enable;
         mtu 9192;
         unit 0 {
             family inet {
                 address 164.113.192.130/30;
             }
             family mpls;
         }
     }
     ge-0/0/1 {
         description "MPLS-enabled Drop Port -- to CE";
         mtu 9192;
         encapsulation ethernet-ccc;
         unit 0 {
             }
         }
     }
     lo0 {
         description loopback;
         unit 0 {
             family inet {
                 address 164.113.199.108/32;
             }
         }
     }
}
protocols {
     mpls {
         interface all;
     }
     ospf {
         traffic-engineering;
         area 0.0.0.0 {
             interface ge-0/0/0.0;
             interface lo0.0;
             interface ge-0/0/1.0 {
                 disable;
             }
         }
     }
     ldp {
         interface ge-0/0/0.0;
         interface ge-0/0/1.0 {
             disable;
         }
         interface all;
     }
     l2circuit {
         neighbor 164.113.199.103 {
             interface ge-0/0/1.0 {
                 virtual-circuit-id 2;
                 mtu 9178;
             }
         }
     }
}

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20090414/c902e0ee/attachment.html>