[f-nsp] IPv6 on BigIron?

[Kenneth Hellmann]

You need the B2P image for IPv6.

-----Original Message-----
From: foundry-nsp-bounces at puck.nether.net
[mailto:foundry-nsp-bounces at puck.nether.net] On Behalf Of Gunther Stammwitz
Sent: Tuesday, December 08, 2009 7:31 PM
To: clement at cavadore.net
Cc: 'Joseph Hardeman'; foundry-nsp at puck.nether.net
Subject: Re: [f-nsp] IPv6 on BigIron?

Hello Clement,

which exact software tree are you referring to?

I was trying to enable v6 on 8001u (08.0.01uT53 / B2R08001u.bin) but didn't
have success.
Is the B2R-image the correct version set? My modules are jetcore (J-BxGMR4).


Can't find the appropriate manual :-( 
The v6 manual from April (IPv6_April2009_Config_Guide.pdf) just says
IronWare
Software 07.7.02 and higher.


Thanks,
Gunther

> -----Ursprüngliche Nachricht-----
> Von: foundry-nsp-bounces at puck.nether.net [mailto:foundry-nsp-
> bounces at puck.nether.net] Im Auftrag von Clement Cavadore
> Gesendet: Donnerstag, 8. Oktober 2009 00:55
> An: Joseph Hardeman
> Cc: foundry-nsp at puck.nether.net
> Betreff: Re: [f-nsp] IPv6 on BigIron?
> 
> Hi,
> 
> 
> Le mercredi 07 octobre 2009 à 18:19 -0400, Joseph Hardeman a écrit :
> > Yes, the J-BxGMR4 will do IPv6, but you need to have a software
> > version greater than 08.0.x.
> 
> 
> More precisely: You need Jetcore module *and* software equals to 08.x.
> 9.x or 7.x do not have any IPv6 features.
> 
> However, Jetcore manager runs a fully software-based IPv6 routing.
> 
> Regards,
> 
> Clément
> 
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp


_______________________________________________
foundry-nsp mailing list
foundry-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/foundry-nsp