[f-nsp] Port state blocking?
Chuck Ufarley
markentime at gmail.com
Fri Feb 20 16:19:11 EST 2009
Thanks. At this point I'm just trying to get the ports to come up, so it's
the simplest config in the world. 2402 connected via port 26 to SI-GT on
port 4/9 with a crossover cable. It's 11.0 code, and it's worked in other
machines, though I don't have any currently running that code.
2402:
FES2402 Switch#sho run
Current configuration:
!
ver 04.0.00aTc1
!
!
!
!
!
!
!
ip address 192.168.0.64 255.255.255.0
!
!
!
!
!
!
end
FES2402 Switch#sho int e 26
GigabitEthernet26 is up
Link Error Dampening is Disabled
Hardware is GigabitEthernet, address is 000c.db1d.4769 (bia
000c.db1d.4769)
Configured speed 1Gbit, actual 1Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual MDI
Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING
BPDU guard is Disabled, ROOT protect is Disabled
Link Error Dampening is Disabled
STP configured to ON, priority is level0
Flow Control is config enabled, oper enabled, negotiation disabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
IP MTU 1500 bytes
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 640 bits/sec, 1 packets/sec, 0.00% utilization
6461218 packets input, 423261535 bytes, 0 no buffer
Received 4282 broadcasts, 21834 multicasts, 6424644 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants, DMA received 6461218 packets
6746678 packets output, 1994941951 bytes, 0 underruns
Transmitted 189434 broadcasts, 124538 multicasts, 6432706 unicasts
0 output errors, 0 collisions, DMA transmitted 6746678 packets
FES2402 Switch#sho int bri
Port Link State Dupl Speed Trunk Tag Priori MAC Name
1 Down None None None None No level0 000c.db1d.4750
2 Down None None None None No level0 000c.db1d.4751
3 Down None None None None No level0 000c.db1d.4752
4 Down None None None None No level0 000c.db1d.4753
5 Down None None None None No level0 000c.db1d.4754
6 Down None None None None No level0 000c.db1d.4755
7 Down None None None None No level0 000c.db1d.4756
8 Down None None None None No level0 000c.db1d.4757
9 Down None None None None No level0 000c.db1d.4758
10 Down None None None None No level0 000c.db1d.4759
11 Down None None None None No level0 000c.db1d.475a
12 Down None None None None No level0 000c.db1d.475b
13 Down None None None None No level0 000c.db1d.475c
14 Down None None None None No level0 000c.db1d.475d
15 Down None None None None No level0 000c.db1d.475e
16 Down None None None None No level0 000c.db1d.475f
17 Down None None None None No level0 000c.db1d.4760
18 Down None None None None No level0 000c.db1d.4761
19 Down None None None None No level0 000c.db1d.4762
20 Down None None None None No level0 000c.db1d.4763
21 Down None None None None No level0 000c.db1d.4764
22 Down None None None None No level0 000c.db1d.4765
23 Up Forward Full 100M None No level0 000c.db1d.4766
24 Up Forward Full 100M None No level0 000c.db1d.4767
25 Up Forward Full 1G None No level0 000c.db1d.4768
26 Up Forward Full 1G None No level0 000c.db1d.4769
FES2402 Switch#
SI-GT:
ServerIronGT E-1#sho run
!Building configuration...
!Current configuration : 378 bytes
!
ver 11.0.00TD4
!
module 1 bi-0-port-wsm6-management-module
module 3 bi-jc-2-port-gig-module
module 4 bi-jc-16-port-gig-copper-module
!
context default
!
aaa authentication web-server default local
no enable aaa console
telnet server
username admin password .....
snmp-server
!
interface ethernet 4/9
ip address 192.168.0.77 255.255.255.0
!
end
ServerIronGT E-1#sho int e 4/9
GigabitEthernet4/9 is down, line protocol is down
Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia
000c.dbb5.b668)
Configured speed auto, actual unknown, configured duplex fdx, actual
unknown
Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING
STP configured to ON, priority is level0, flow control enabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation
ethernet
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
6096 packets input, 507641 bytes, 0 no buffer
Received 4256 broadcasts, 1838 multicasts, 2 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants, DMA received 0 packets
0 packets output, 0 bytes, 0 underruns
Transmitted 0 broadcasts, 0 multicasts, 0 unicasts
0 output errors, 0 collisions, DMA transmitted 0 packets
ServerIronGT E-1#sho int bri
Port Link State Dupl Speed Trunk Tag Priori MAC Name
4/1 Down None None None None No level0 000c.dbb5.b660
4/2 Down None None None None No level0 000c.dbb5.b661
4/3 Down None None None None No level0 000c.dbb5.b662
4/4 Down None None None None No level0 000c.dbb5.b663
4/5 Down None None None None No level0 000c.dbb5.b664
4/6 Down None None None None No level0 000c.dbb5.b665
4/7 Down None None None None No level0 000c.dbb5.b666
4/8 Down None None None None No level0 000c.dbb5.b667
4/9 Down None None None None No level0 000c.dbb5.b668
4/10 Down None None None None No level0 000c.dbb5.b669
4/11 Down None None None None No level0 000c.dbb5.b66a
4/12 Down None None None None No level0 000c.dbb5.b66b
4/13 Down None None None None No level0 000c.dbb5.b66c
4/14 Down None None None None No level0 000c.dbb5.b66d
4/15 Down None None None None No level0 000c.dbb5.b66e
4/16 Down None None None None No level0 000c.dbb5.b66f
ServerIronGT E-1#
On Fri, Feb 20, 2009 at 12:06 PM, Daniel Kekai
<Daniel.Kekai at microsoft.com>wrote:
> Send the output on the FES side interface and if possible the configs for
> both the GT and FES
>
> Also do you have this setup working with other GT's – FES? If so are you
> running the same code?
>
>
>
> -D
>
>
>
> *From:* Chuck Ufarley [mailto:markentime at gmail.com]
> *Sent:* Friday, February 20, 2009 11:17 AM
> *To:* Daniel Kekai
> *Cc:* foundry-nsp at puck.nether.net
> *Subject:* Re: [f-nsp] Port state blocking?
>
>
>
> It seems to be disabled. Should I enable it? This hasn't been an issue in
> past configs.
>
> ServerIronGT E-1#sho span
>
> Spanning-tree is not configured on port-vlan 1.
>
> Thanks again.
>
> On Fri, Feb 20, 2009 at 11:01 AM, Daniel Kekai <Daniel.Kekai at microsoft.com>
> wrote:
>
> Check your spanning tree
>
> -D
>
>
>
> *From:* foundry-nsp-bounces at puck.nether.net [mailto:
> foundry-nsp-bounces at puck.nether.net] *On Behalf Of *Chuck Ufarley
> *Sent:* Friday, February 20, 2009 9:51 AM
> *To:* foundry-nsp at puck.nether.net
> *Subject:* [f-nsp] Port state blocking?
>
>
>
> This might be a silly question, but I can't get a port to come up on a
> ServerIron. I enabled the interface and connected it properly to a
> FES-X2402 switch, but the J-B16GC and the J-B2Gx ports just won't come up
> and forward. The cards have worked in other configs, but I can't get
> anything to come out of "blocking" mode. Here are the shows (any help
> greatly appreciated):
>
> ServerIronGT E-1#sho run
> !Building configuration...
> !Current configuration : 378 bytes
> !
> ver 11.0.00TD4
> !
> module 1 bi-0-port-wsm6-management-module
> module 3 bi-jc-2-port-gig-module
> module 4 bi-jc-16-port-gig-copper-module
> !
> context default
> !
> aaa authentication web-server default local
> no enable aaa console
> telnet server
> username admin password .....
> snmp-server
> !
> interface ethernet 4/9
> ip address 192.168.0.77 255.255.255.0
> !
> end
>
> ServerIronGT E-1#sho run
> !Building configuration...
> !Current configuration : 378 bytes
> !
> ver 11.0.00TD4
> !
> module 1 bi-0-port-wsm6-management-module
> module 3 bi-jc-2-port-gig-module
> module 4 bi-jc-16-port-gig-copper-module
> !
> context default
> !
> aaa authentication web-server default local
> no enable aaa console
> telnet server
> username admin password .....
> snmp-server
> !
> interface ethernet 4/9
> ip address 192.168.0.77 255.255.255.0
> !
> end
>
> ServerIronGT E-1#sho mod
> Module Status Ports Starting MAC
> S1: B0GMR WSM6 Management Module, SYSIF 2 M6, ACTIV 0
> S2:
> S3: J-BxG2 JetCore Gig Fiber Module, SYSIF OK 2 000c.dbb5.b640
> S4: J-BxGC16 JetCore Gig Copper Module, SY OK 16 000c.dbb5.b660
> ServerIronGT E-1#sho int e 4/9
> GigabitEthernet4/9 is down, line protocol is down
> Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia
> 000c.dbb5.b668)
> Configured speed auto, actual unknown, configured duplex fdx, actual
> unknown
> Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING
> STP configured to ON, priority is level0, flow control enabled
> mirror disabled, monitor disabled
> Not member of any active trunks
> Not member of any configured trunks
> No port name
> Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation
> ethernet
> 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
> 300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
> 991 packets input, 77378 bytes, 0 no buffer
> Received 581 broadcasts, 410 multicasts, 0 unicasts
> 0 input errors, 0 CRC, 0 frame, 0 ignored
> 0 runts, 0 giants, DMA received 0 packets
> 0 packets output, 0 bytes, 0 underruns
> Transmitted 0 broadcasts, 0 multicasts, 0 unicasts
> 0 output errors, 0 collisions, DMA transmitted 0 packets
> ServerIronGT E-1#
>
> +++++
>
> Thanks much, everyone.
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/foundry-nsp/attachments/20090220/d5390424/attachment.html>
More information about the foundry-nsp
mailing list