[f-nsp] XMR force to 1000-full

[Nuno Vieira - nfsi telecom]

gig-default neg-full-auto should be enough, as, it will force at 1000-Full, disabling negotiation.

---
Nuno Vieira
nfsi telecom, lda.

nuno.vieira at nfsi.pt
Tel. (+351) 21 949 2300 - Fax (+351) 21 949 2301
http://www.nfsi.pt/



----- "Rens" <rens at autempspourmoi.be> wrote:

> (config-if-e1000-1/6)#speed-duplex 1000-full
> Error - can't change speed and duplex mode
> 
> -----Original Message-----
> From: Nuno Vieira [mailto:nuno.vieira at nfsi.pt] 
> Sent: jeudi 29 janvier 2009 10:59
> To: Rens
> Cc: foundry-nsp at puck.nether.net
> Subject: Re: [f-nsp] XMR force to 1000-full
> 
> Hi,
> 
> Can you paste the error ?
> 
> The proper way of doing that is:
> 
> interface ethernet x/y
>   gig-default neg-full-auto
>   speed-duplex 1000-full      <--- don't work on some versions, but
> the 
> prior command does the proper trick.
> !
> 
> regards,
> --nvieira
> 
> Rens wrote:
> > Hi,
> > 
> >  
> > 
> > I'm unable to change the interface of a XMR to 1000-full, I keep
> getting 
> > an error message.
> > 
> >  
> > 
> > Is this normal? The provider of the circuit where I want to connect
> this 
> > port says I have to force to 1000-full.
> > 
> >  
> > 
> > Regards,
> > 
> >  
> > 
> > Rens
> > 
> > 
> >
> ------------------------------------------------------------------------
> > 
> > _______________________________________________
> > foundry-nsp mailing list
> > foundry-nsp at puck.nether.net
> > http://puck.nether.net/mailman/listinfo/foundry-nsp