[f-nsp] loss on jetcore
kgb
kgb at bginfo.net
Thu Jul 1 09:20:52 EDT 2010
On Thursday 01 July 2010 15:49:59 DELOBEL Gary wrote:
> temperature is as usual
>
> telnet at br1-uro(config-bgp)#sh cha
> power supply 1 ok
> power supply 2 ok
> power supply 1 to 2 from left to right
> fan 1 (left side panel, back fan) ok
> fan 2 (left side panel, front fan) ok
> fan 3 (rear/back panel, left fan) ok
> fan 4 (rear/back panel, right fan) ok
> Current temperature : 30.5 C degrees
just try decrease temperature < 28C :)
> Warning level : 45 C degrees, shutdown level : 55 C degrees
> Boot Prom MAC: 000c.db47.a800
>
> Le 01/07/2010 13:30, kgb a écrit :
> If problem is not in line / UTP,FO/ then check your temperatute.
> In this old chassis i have packet lost when temperature is up then 28-30C
>
> sorry for my bad english :0
> make fun
>
> Mitko
>
> On Thursday 01 July 2010 13:47:17 DELOBEL Gary wrote:
>
> Hi,
>
> we have some loss on jetcore router (~10%) but cpu at 1% and memory at 67%
>
> telnet at br1-uro(config-bgp)#sh ver
> SW: Version 08.0.01tT53 Copyright (c) 1996-2004 Foundry Networks, Inc.
> Compiled on Mar 04 2009 at 23:23:14 labeled as B2P08001t
> (4147833 bytes) from Secondary B2P08001t.bin
> HW: NetIron 400 Router, SYSIF version 21, Serial #: Non-exist
> ==========================================================================
> SL 1: J-BxGMR4 JetCore Management Module, SYSIF 2 (Mini GBIC), M4, ACTIVE
> Serial #: CH13041971
> 4096 KB BRAM, JetCore ASIC IGC version 49, BIA version 8a
> 32768 KB PRAM and 2M-Bit*1 CAM for IGC 0, version 0449
> 32768 KB PRAM and 2M-Bit*1 CAM for IGC 1, version 0449
> ==========================================================================
> Active management module:
> 466 MHz Power PC processor 750 (version 8/8302) 66 MHz bus
> 512 KB boot flash memory
> 16384 KB code flash memory
> 512 KB SRAM
> 512 MB DRAM
> The system uptime is 3 hours 34 minutes 1 seconds
> The system started at 07:12:16 GMT+00 Thu Jul 01 2010
>
> The system : started=warm start reloaded=by "reload"
> Crash time : 11:42:20 GMT+00 Sat Feb 20 2010
>
> telnet at br1-uro(config-bgp)#sh pro cpu
> Process Name 5Sec(%) 1Min(%) 5Min(%) 15Min(%) Runtime(ms)
> ACL 0.00 0.00 0.00 0.00 0
> ARP 0.23 0.22 0.26 0.23 30821
> BGP 0.08 0.43 0.29 0.29 277288
> DOT1X 0.00 0.00 0.00 0.00 0
> GVRP 0.00 0.00 0.00 0.00 0
> ICMP 0.00 0.00 0.00 0.00 495
> IP 0.30 0.48 0.46 0.43 72094
> IP_M 0.00 0.00 0.00 0.00 234
> IPUP 0.06 0.11 0.11 0.11 21997
> ISIS 0.00 0.00 0.00 0.00 0
> L2VLAN 0.01 0.02 0.02 0.02 2819
> NAT 0.00 0.00 0.00 0.00 0
> OSPF 0.00 0.00 0.00 0.00 0
> RIP 0.00 0.00 0.00 0.00 1
> STP 0.00 0.00 0.00 0.00 39
> VRRP 0.03 0.04 0.04 0.04 6313
> IPv6 0.02 0.02 0.03 0.03 4110
> ICMP6 0.05 0.06 0.06 0.06 9226
> ND6 0.00 0.00 0.00 0.00 12
> RIPng 0.00 0.00 0.00 0.00 12
> OSPFv3 0.00 0.00 0.00 0.00 0
> IPV6_RX 0.00 0.00 0.00 0.00 484
>
>
> same after reboot
>
> do you have any idea?
>
> Best Regards
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp
>
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp
More information about the foundry-nsp
mailing list