[f-nsp] Not able to use XMR 10 gig linecard

[Lutz Schotte]

Card is in interactive mode. In most cases there is incompatible code on its
flash.
Copy the actual running images to the mgm first, and then from there to the
10ge4.
After a reset of s2 the module will run.
Rgds
Lutz

-----Ursprüngliche Nachricht-----
Von: foundry-nsp-bounces at puck.nether.net
[mailto:foundry-nsp-bounces at puck.nether.net] Im Auftrag von Remco Bressers
Gesendet: Dienstag, 9. November 2010 16:58
An: foundry-nsp at puck.nether.net
Betreff: [f-nsp] Not able to use XMR 10 gig linecard

Hi,

The other day, i inserted a brand new NI-XMR-10Gx4 in an XMR-4, but it
won't work correctly.
If i do a "show module", i see the following output on the slot :

S2: NI-XMR-10Gx4 4-port 10GbE Module  CARD_STATE_INTERACTIVE    20
0012.f2f5.d128
(S2: Configured as NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module)

What is the correct procedure to configure S2 as ni-xmr-10gx4 ?

I tried :

telnet at r(config)#module 2 ni-xmr-4-port-10g
Error: Please remove module from slot 2 first
telnet at r(config)#

Is this the only (and correct) way?

-- 
Kind regards,
Signet bv

Remco Bressers
_______________________________________________
foundry-nsp mailing list
foundry-nsp at puck.nether.net
http://puck.nether.net/mailman/listinfo/foundry-nsp