[f-nsp] SFP-T in XMR

Ronald Voermans r.voermans at global-datacenter.nl
Thu Feb 17 10:29:51 EST 2011


Jorik,

Chances are, since you're using a third party SFP, that it doesn't match for the XMR. We've had recently 4 different SFP's (E1MG-TX) programmed for Brocade devices of which only 1 worked in a MLX, while all 4 worked on a FESX.

Rgds,
Ronald Voermans

Op 17 feb 2011, om 16:20 heeft Jorik Jonker het volgende geschreven:

> Some further info: the SFP-T/E1MG-TX is not an official Brocade one, but one from a third party (SmartOptics), which has specifically programmed it for use in a Brocade device. We have extended experience with this particular vendor producing quality OEM but brand-recognized optics. 
> 
> Of course there is a small chance that we have a wrong (set of) optic(s), but the fact that a RX4 is happy with it suggests me that we have to trick the XMR into something.
> 
> Best regards,
> 
> Jorik Jonker
> Special Projects, Netherlands
> jorik.jonker at eu.equinix.com 
> +31 53 434 0570 TEL
> +31 53 436 3098 FAX
> 
> KvK: 06092246
> 
> EQUINIX
> 
> 
> -----Original Message-----
> From: foundry-nsp-bounces at puck.nether.net [mailto:foundry-nsp-bounces at puck.nether.net] On Behalf Of Jorik Jonker
> Sent: donderdag 17 februari 2011 15:57
> To: foundry-nsp at puck.nether.net
> Subject: [f-nsp] SFP-T in XMR
> 
> Hi all,
> 
> Just ran into this bizarre problem when using a E1MG-TX (1G copper RJ45 SFP) in a NI-XMR-1Gx20-SFP board in a XMR. 
> 
> The "other side", in this case a laptop, HP switch, FESX424 or whatever 1G RJ45 capable device thinks it has link up (Full 1G) while the XMR holding the SFP still has link down. When I put this SFP into a RX-BI-24F in a RX, both sides have 1G full link up. When I use a different XMR or a different board I get the same situation.
> 
> Is there some mysterious setting that I should fiddle with in order to convince the XMR to proceed into "link up"?
> 
> Best regards,
> 
> Jorik Jonker
> 
> 
> This email is from Equinix Europe Limited or one of its associated/subsidiary companies. This email, and any files transmitted with it, contains information which is confidential, may be legally privileged and is solely for the use of the intended recipient. If you have received this email in error, please notify the sender and delete this email immediately.  Equinix Europe Limited.  Registered Office: Quadrant House, 4 Thomas More Square, London E1W 1YW.  Registered in England and Wales, No. 6293383.
> 
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp
> 
> _______________________________________________
> foundry-nsp mailing list
> foundry-nsp at puck.nether.net
> http://puck.nether.net/mailman/listinfo/foundry-nsp
> 





More information about the foundry-nsp mailing list